Panasonic SC-HC35 User Manual

Page of 28
6
RQ
T
X
12
60
Attaching the unit to a wall (optional)
∫ Supplied accessories
≥ 1 Safety holder screw (Silver)
≥ 2 Safety holder screws C
 
(Black)
≥ 1 Safety holder D (4)
≥ 2 Safety holders E (4)
≥ 2 Wall mount brackets
≥ 2 Rear pads
∫ Commercially available accessories 
(not supplied)
≥ 4 Wall bracket fixing screws F
≥ 1 Safety holder fixing screw G
≥ Use screws with a nominal diameter of ‰4 mm (
5
/
32
q), which are suitable to 
the material of the wall (e.g., wood, steel, concrete, etc.)
1
Detach the stand from the unit.
Unscrew the fixing screw A (4 pieces) at the bottom 
of the unit.
Gently pull the bottom of the stand and slide the 
stand off the unit.
≥ Keep the removed screws and stand in a safe place.
Installation accessories
≥ Keep the wall mount brackets out of reach of children to prevent 
swallowing.
≥ Keep the rear pads out of reach of children to prevent swallowing.
≥ Keep the screws out of reach of children to prevent swallowing.
≥ Keep the safety holder out of reach of children to prevent swallowing.
Safety precautions
WARNING!
≥ Only a qualified building contractor shall install or uninstall this 
unit.
– Improper installation may cause the unit to fall, resulting in injury.
≥ To prevent injury, the unit must be securely attached to the wall in 
accordance with the installation instructions.
≥ Do not install the unit where it cannot support the load.
– If the mounting parts are not strong enough, this may cause the unit to 
fall, resulting in injury.
≥ Do not use installation methods other than instructed.
– This may cause the unit to fall and be damaged, resulting in injury.
≥ Do not install the unit at locations other than vertical walls.
– This may cause the unit to fall and be damaged, resulting in injury.
≥ Take the safety factor for mounting strength into account.
– Insufficient strength will cause the unit to fall, resulting in injury.
≥ The wall on which the unit is to be attached to should be capable of 
supporting 33 kg (72.8 lbs) per screw.
– Insufficient strength of the walls will cause the unit to fall in the long 
run.
≥ Do not disassemble or modify the wall-mounting hanger.
– This will cause the unit to fall and be damaged, resulting in injury.
CAUTIONS!
≥ Do not install this unit at humid or dusty locations, or locations 
where airborne grease or steam may come into contact with the 
unit, or under an air conditioner where water may drip onto the unit.
– This may have negative impact on the unit, resulting in fire or electric 
shock.
≥ Secure enough space of more than 30 cm (11 
13
/
16
q) above the main 
unit and more than 10 cm (3 
15
/
16
q) on the left and right sides 
respectively. Keep space between the wall and rear of the unit clear 
of obstructions.
– Blocking the exhaust holes on the main unit may result in fire.
≥ Use the designated components for installation.
– Otherwise, the main unit may fall and be damaged, resulting in injury.
≥ Prevent the mounting screws or power cord from coming into 
contact with metal parts inside the wall during installation.
– Failure to do so may cause electric shock.
≥ When removing the main unit, remove the wall mounting screws as 
well.
– Otherwise the wall mounting screws may hit a person and lead to 
injury.
≥ Install the unit at a height where the EXT-IN AUX jack
 
and operation 
buttons can be seen for safe operation.
– Operating at improper position may cause the unit to fall and be 
damaged, resulting in injury.
∫ Notes on installation
≥ Before installation, read the “Safety precautions” and “Wall mount 
instructions” for correct installation.
≥ For optimal performance and to prevent potential problems, do not 
install this unit:
– at locations other than vertical walls.
– near a sprinkler or a sensor.
– near high-voltage lines or power sources.
– near heating device.
– at locations where the unit is subject to vibration or impact.
– near sources of magnetism, heat, vapor, airborne grease, etc.
– at locations where there may be water droplets (e.g. under an air 
conditioner).
≥ Do not install this unit under ceiling lights (e.g. spotlight, halogen 
light, etc.).
– Failure to do so may bend the cabinet or lead to damage caused by 
high heat.
≥ Use a proper installation method that suits the structure and 
material of the wall.
≥ Use a soft blanket or cloth to prevent damage to the product or floor 
during installation.
≥ When tightening screws, make sure the screws are not 
loosely-tightened or overtightened.
≥ Secure a safe surrounding area and pay attention to safety during 
installation.
≥ Panasonic is not liable for incidental or consequential damages 
resulting from improper installation or operation.
Wall mount instructions
Before installation, turn the unit off and disconnect the AC power 
supply cord from the AC outlet.
Bottom of main unit 
Stand
Soft blanket or cloth
Fixing screw 
A
SC-HC55_35-RQTX1260.book  6 ページ  2011年4月4日 月曜日 午後4時50分