Panasonic SC-AK960 User Manual

Page of 28
6
RQT8043
RQTX0169
L
A
N
G
 -
 5
LANG - 5
L
A
N
G
 -
 4
LANG - 4
F
R
A
N
Ç
A
IS
FRANÇAIS
D
A
N
S
K
DA
N
S
K
E
N
G
L
IS
H
ENGLISH
Optional antenna connections
Optional antenna connections
Use outdoor antenna if radio reception is poor.
Note:
Disconnect the outdoor antenna when the unit is not in use. Do not use the outdoor antenna during a lightning storm.
FM outdoor antenna
AM outdoor antenna
Rear panel 
of this unit
FM outdoor antenna 
(not included)
75 
Ω coaxial cable 
(not included)
Rear panel 
of this unit
AM outdoor antenna 
(not included)
AM loop antenna 
(included)
5-12 m
(16-40 ft)
•  Disconnect the FM indoor antenna.
•  The antenna should be installed by a competent technician.
•  Run a piece of vinyl wire horizontally across a window or other conve-
nient location.
•  Leave the loop antenna connected.
Preparing the remote control
AA/R6/LR6
 Batteries
•  Insert so the poles (+ and –) match those in the remote control.
•  Remove if the remote control is not going to be used for a long period of time. Store in a 
cool, dark place.
•  Do not use rechargeable type batteries.
•  Do not heat or expose to fl ame.
•  Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long period 
of time with doors and windows closed.
•  Mishandling of batteries in the remote control can cause electrolyte leakage, which may 
cause a fi re.
Do not:
•  mix old and new batteries.
•  use different types of batteries at the same time.
•  take apart or short circuit;
•  attempt to recharge alkaline or manganese batteries.
•  use batteries if the covering has been peeled off.
 Use
  Aim at the remote control sensor, avoiding obstacles, at a maximum range of 7 m 
(23 feet) directly in front of the unit.
  Refer to page 7 for the remote control sensor position.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or 
equivalent type recommended by the manufacturer. Dispose of used batteries according 
to the manufacturer’s instructions.
DEMO function
7, STOP, –DEMO
When the unit is fi rst plugged in, a demonstration of its functions may be shown on the 
display.
If the demo setting is off, you can show a demonstration by selecting “DEMO ON”.
Press and hold [
7, STOP, – DEMO].
The display changes each time the button is held down.
NO DEMO (off) 
Ô DEMO ON (on)
While in standby mode, select “NO DEMO” to reduce power consumption.
Note:
DEMO function cannot be turned on when DIMMER is on.
Getting started (continued)
RQTX0169-P.indd   6
RQTX0169-P.indd   6
7/18/08   9:24:39 AM
7/18/08   9:24:39 AM