Panasonic RQT9708-1P User Manual

RQT9708

You can set the timer so this unit turns on at a 
certain time every day.
Preparation
Set the clock (> 13).

∫ Setting the timer

Press [SETUP] repeatedly to select 
“TIMER ADJ” and then press [OK].

Press [3, 4] to set the starting time 
(“ON TIME”) and then press [OK].

Press [3, 4] to set the finishing time 
(“OFF TIME”) and then press [OK].

≥ To display the timer settings, press [SETUP] repeatedly to 

select “TIMER ADJ” and then press [OK] once.
(During standby, press [iPod MENU, DISPLAY] twice.)

≥ The music source and volume will also be displayed if the 

timer is turned on. (> below)

∫ Turn the timer on

Select the music source*

1

 and set the desired 

volume.

Press [SETUP] repeatedly to select 
“TIMER SET” and then press [OK].

Press [3, 4] to select “SET” and then press 
[OK].

≥ “

F” is displayed.

Press [Í] to turn the unit off.

*1: “CD”, “IPOD” and “FM” can be set as the music source.
≥ This unit can be used as normal after the timer is set, 

however:
≥ Turn the unit to standby mode before the timer start time.
≥ Even if the audio source or the volume is changed, the 

timer will still use the audio source and volume that was 
set when the timer was turned on.

≥ To turn the timer off, select “OFF” in step 3.
≥ The unit will turn on at the preset time, with the volume 

increasing gradually to the preset level.

The sleep timer can turn the unit off after a set time.

Press [SETUP] repeatedly to select “SLEEP” 
and then press [OK].

Press [3, 4] to set the time (in minutes) and 
then press [OK].

“SLEEP 30” 

,. “SLEEP 60” ,. “SLEEP 90” ,. “SLEEP 120”

^----------------------.

 OFF (Cancel) 

(----------------------J

≥ The remaining time is indicated on the unit’s display except 

when other operations are performed.

≥ The play timer and sleep timer can be used together. The 

sleep timer always has priority.

As a factory preset, this unit will always turn off 
automatically if there is no sound output and no 
operation for 30 minutes.
To cancel this function

Press [SETUP] repeatedly to select 
“AUTO OFF” and then press [OK].

Press [3, 4] to select “OFF” and then press 
[OK].

≥ To turn automatic standby on, select “ON” in step 2.
≥ This setting cannot be selected when “FM” is the source.

The brightness of this unit’s display can be 
changed.

Press [SETUP] repeatedly to select “DIMMER” 
and then press [OK].

Press [3, 4] to select “ON” and then press 
[OK].

To cancel the dimmer, select “OFF” in step 2.

When other Panasonic equipment responds to the 
supplied remote control, change the remote control 
code.

Press [CD] to select “CD”.

Press and hold [CD] on the main unit and [3] 
on the remote control until the main unit’s 
display shows “REMOTE 2”.

Press and hold [OK] and [3] on the remote 
control for at least 4 seconds.

To change the mode back to “REMOTE 1”, repeat the steps 
above by replacing [3] with [4].

SC-HC57~RQT9708.book  14 ページ  ２０１２年３月２日　金曜日　午後２時４分