ONKYO DR-90 User Manual

10

If the TV or monitor is equipped with an S video
input, make the S video connection in addition
to the normal video connection. (The S video
connection will provide higher quality picture
playback.) In this case, set “Video Out Select”
to “S Video” using the menu explained in
“Customizing the Function Settings” starting
from page 44 after completing steps on page
17. See page 49 for direct information.

Set “Video Out Select” to “RGB” using the
menu explained in “Customizing the Function
Settings” starting from page 44 after
completing steps on page 17. See page 49 for
direct information.

• Refer also to the instruction manual of the TV.
• When you connect the DVD Receiver to the TV, be sure to turn off the

power and unplug both the units from the mains before making any
connections.

• Connect the DVD Receiver to the TV directly. If you connect the DVD

Receiver to a VCR, TV/VCR combination, or video selector, the
playback picture may be distorted as DVD videos are copy protected.

(White)

(Yellow)

To video input

To S video input

L (White)

R (Red)

S video
connection cable

Stereo audio connection cable

To audio outputs

(Red)

(White)

L (White)

To audio outputs

Stereo audio connection cable

Video connection cable

: Signal flow

• Connect the plugs securely.

• Note that one SCART cable is supplied.

Incomplete

Insert completely

Connect the DVD Receiver and your TV using the
supplied SCART cable.

Set “Video Out Select” to “S Video” using the menu
explained in “Customizing the Function Settings”
starting from page 44 after completing steps on page
17. See page 49 for direct information.

Set “Video Out Select” to “RGB” using the menu
explained in “Customizing the Function Settings”
starting from page 44 after completing steps on page
17. See page 49 for direct information.

: Signal flow

(Red)

Do not connect the mains lead
at this time.

Both the S video and video connections are
necessary, otherwise the picture from equipment
to be connected on the next page may not be
output to the TV.

R (Red)

To SCART input

Connect the SCART cable directly to the TV.
No sound is reproduced if you connect it to the
VCR connected to the TV.

If there is no center speaker and your TV has audio inputs, you may be able to use your TV’s
speaker(s) as the center speaker(s). If you connect the TV to this jack, you need to set up the TV
speaker(s) as the center speaker(s) following steps in “Speaker Setup” on page 18.