ONKYO DR-90 User Manual

40

The high frequency/high quantization sound signals below are
converted into 48 kHz/16 bit sound signals and sent to the
speakers when the “Audio Out Select” (sound signal
conversion method) is set to the standard setting, “Bitstream.”

• 48 kHz/24 bit
• 96 kHz/16 bit
• 96 kHz/20 bit
• 96 kHz/24 bit

To listen to the high-frequency (kHz)/hight-quantization (bit)
format sounds in their original sound quality, follow the steps
below.

As you see 

a

 in the table titled “Sound

from the speakers” on the opposite page,
the DVD videos recorded in 48 kHz/24 bit,
96 kHz/16 bit, 96 kHz/20 bit, and 96 kHz/
24 bit are reproduced through the
speakers at the same kHz and bit rate
respectively.

Skip the rest of the steps by pressing
ENTER repeatedly.

See “Using Onkyo’s original sound effects
– DSP selection” on page 31.

See previous
page.

• The “Audio Out Select” setting in the setting menu (see page 50) is

for  automatic selection of the sound conversion method when the
disc is inserted. Therefore, the selection in this section will not
change the setting of “Audio Out Select” in the setting menu.

• When you turn on the DVD Receiver or replace a disc, the DVD

Receiver returns to the automatic setting in the setting menu (See
page 44.)

The reproduced disc sound will be output in the most suitable format automatically through the
connected speakers and output connector/jacks on the DVD Receiver when “Audio Out Select”
in the setting menu is set to “Bitstream” (see page 50).
However, you may need to convert the sound format in different ways depending on your
purpose and preference.

For example, when you wish to:
• Listen to the high-frequency (kHz)/high-quantization (bit) format source in its original sound

quality (see below), or

• Record the DVD video sound reproduced in the DOLBY DIGITAL format using recording

equipment such as an MD recorder connected to the DIGITAL OUTPUT OPTICAL connector
on the DVD Receiver (see next page).

CLEAR

REMOTE CONTROLLER                                               

RC-399M

Audio:

Audio OUT Select : Bitstream

ENG PCM

2CH

1

Audio:

Audio OUT Select : 96k Sound

ENG PCM

2CH

1

The current audio setting is displayed for
about 3 seconds.

Each time you press  / , the setting
changes as follows:

 Bitstream 

↔

 96k Sound 

↔

 PCM

↑

↑

For details about “Bitstream,” “96k Sound,”
and “PCM,” see the explanation on page
50 and table on the opposite page.

The current sound signal
conversion method