Panasonic SC-BT100 User Manual

RQT9129

1 Press [FM/AM] to select “FM” or “AM”.

Main unit: Press [SELECTOR].

2 Press [

6, 5] to select the frequency.

Main unit: Press [

X] or [W].

≥When a radio broadcast is being received, “TUNED” lights in the 

display.

≥When a stereo broadcast is being received, “ST” lights in the 

display.

≥To start automatic tuning, press and hold [6, 5] until the frequency 

starts scrolling. Tuning stops when a station is found.

Up to 30 stations can be set in each band, FM and AM.

1 Press [FM/AM] to select “FM” or “AM”.
2 Press [

6, 5] to select the frequency.

3 Press [OK].

“P” and “M” begin to flash.

4 Press the numbered buttons to enter 

≥To select a 1-digit number

e.g., “1”: [1]

> [OK].

≥To select a 2-digit number

e.g., “12”: [1]

> [2].

≥A station previously stored is overwritten when another station is stored in the same 

channel preset.

≥Repeat steps 2 to 4 to set other stations.

1 Press [FM/AM] to select “FM” or “AM”.
2 Press the numbered buttons to select the channel.

≥To select a 1-digit number

e.g., “1”: [1]

> [OK].

≥To select a 2-digit number

e.g., “12”: [1]

> [2].

Alternatively, press [

:, 9] or [2, 1] to select the 

channel.

When “FM” is selected
Press [FM MODE] to display “MONO”.
≥Press the button again to cancel the mode.
≥The mode is also canceled when you change the frequency.
≥This setting can be preset for each broadcasting station. When 

“MONO” appears follow procedures 

3 and 4 in “Presetting stations manually” 

(

> above).

When “AM” is selected
Press [AM BP] to select “AM BP1” or “AM BP2” that receives good reception.
Each time you press the button:
AM BP1

(.AM BP2 (BP=Beat Proof)

Main unit only
The step is factory-set to 0.2-MHz (200-kHz), but you can change it to receive 
broadcasts allocated in 0.1-MHz (100-kHz) steps.
1 Press [SELECTOR] to select “FM”.
2 Press and hold [SELECTOR].

After a few seconds the display changes to show the current minimum frequency. 
Continue to hold the button down. The minimum frequency changes and the step is 
changed.
To return to the original step, repeat steps 

1 and 2.

After changing the setting, previously preset frequencies will be cleared. Preset them 
again.

2, 1]

6, 5]

:, 9]

X], [W]

e.g., “12”

e.g., “12”

e.g., “AM BP1” is selected.

SC-BT100P-ENG.book  18 ページ  ２００８年２月２０日　水曜日　午後６時２２分