ONKYO 29400086 User Manual

Page of 43
En-
3
Precautions
1. AC Fuse—The fuse is located inside the chassis 
and is not user-serviceable. If power does not come 
on, contact your Onkyo authorized service station.
2. Care—From time to time you should wipe off the 
cabinet with a soft cloth. For heavier dirt, dampen a 
soft cloth in a weak solution of mild detergent and 
water, wring it out dry, and wipe off the dirt. 
Following this, dry immediately with a clean cloth. 
Do not use rough material, thinners, alcohol or other 
chemical solvents or cloths since these may damage 
the finish or remove the panel lettering.
Use a vacuum cleaner to remove dust from hard-to-
reach grilles.
3. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE 
FIRST TIME, READ THE FOLLOWING 
SECTION CAREFULLY.
The voltage of the available power supply differs 
according to country or region. Be sure that the 
power supply voltage of the area where this unit will 
be used meets the required voltage (AC 120 V, 
60 Hz) written on the rear panel.
The power cord plug is used to disconnect this unit 
from the AC power source. Make sure that the plug 
is readily operable (easily accessible) at all times.
For Canadian Models
NOTE: 
THIS CLASS B DIGITAL APPARATUS 
COMPLIES WITH CANADIAN ICES-003.
For models having a power cord with a polarized plug:
CAUTION: 
TO PREVENT ELECTRIC SHOCK, 
MATCH WIDE BLADE OF PLUG TO WIDE SLOT, 
FULLY INSERT.
Modèle pour les Canadien
REMARQUE: 
CET APPAREIL NUMÉRIQUE DE 
LA CLASSE B EST CONFORME À LA NORME 
NMB-003 DU CANADA.
Sur les modèles dont la fiche est polarisée:
ATTENTION: 
POUR ÉVITER LES CHOCS 
ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS 
LARGE DE LA FICHE DANS LA BORNE 
CORRESPONDANTE DE LA PRISE ET POUSSER 
JUSQU’AU FOND.
Contents
Getting Started
Installing & Using
Appendix
HTP-770_EnFrEs.book  Page 3  Wednesday, July 29, 2009  10:07 AM