MK Sound CS-35 User Manual
TRIPOLE
®
OR DIPOLE OPERATION (CS-150 ONLY)
To operate in the Tripole
®
mode, the jumper between the terminals labeled "3" and "4" must be in place. To
operate the speaker in the Dipole mode, the jumper between the terminals labeled "3" and "4" must be removed.
Do not throw away or lose this jumper. See Figures 3 and 4.
Do not throw away or lose this jumper. See Figures 3 and 4.
VERY IMPORTANT:
The sensitivity of the speaker is slightly higher in the Tripole
®
position. For
critical listening, when switching from one mode to another, you should re-calibrate the level of the
surround channels.
surround channels.
5. SPEAKER PLACEMENT
The Column Surround speaker takes a unique new approach to producing high-quality sound from the
surround channels in the listening room. Conventional surround speakers must be mounted on the side walls,
back wall, or ceiling of the room in order to produce good sound. But the Column Surround speaker can be
located virtually anywhere in the room to produce a very effective coverage of sound.
back wall, or ceiling of the room in order to produce good sound. But the Column Surround speaker can be
located virtually anywhere in the room to produce a very effective coverage of sound.
COLUMN SURROUND SPEAKER
5
TRIPOLE
SURROUND SPEAKER
MILLER & KREISEL
SOUND CORPORATION
9351 Deering Avenue, Chatsworth, CA 91311
818/701-7010 fax: 818/701-0369 www.mksound.com
818/701-7010 fax: 818/701-0369 www.mksound.com
INPUT
4 ohms
FOR TRIPOLE
OPERATION:
install jumper
between
terminals
3 and 4
DO NOT CONNECT YOUR
AMPLIFIER TO TWO RED
TERMINALS.
1
3
2
4
FOR THX
(DIPOLE)
(DIPOLE)
OPERATION:
remove jumper
between
terminals
3 and 4
Connect your
amplifier to
terminals
1 and 2
For remote control operation,
see your owner's manual.
+
-
LEFT SURROUND
+
-
RIGHT SURROUND
WIRING FOR DIPOLE OPERATION
(CS-150 ONLY)
(Only one channel is shown)
Disconnect the Jumper between
terminals 3 and 4
terminals 3 and 4
FIGURE 3
+
-
LEFT SURROUND
+
-
RIGHT SURROUND
TRIPOLE
SURROUND SPEAKER
MILLER & KREISEL
SOUND CORPORATION
9351 Deering Avenue, Chatsworth, CA 91311
818/701-7010 fax: 818/701-0369 www.mksound.com
818/701-7010 fax: 818/701-0369 www.mksound.com
INPUT
4 ohms
FOR TRIPOLE
OPERATION:
install jumper
between
terminals
3 and 4
DO NOT CONNECT YOUR
AMPLIFIER TO TWO RED
TERMINALS.
1
3
2
4
FOR THX
(DIPOLE)
(DIPOLE)
OPERATION:
remove jumper
between
terminals
3 and 4
Connect your
amplifier to
terminals
1 and 2
For remote control operation,
see your owner's manual.
WIRING FOR TRIPOLE
®
OPERATION (CS-150 ONLY)
(Only one channel is shown)
Connect the Jumper
between terminals 3 and 4
(Factory default)
between terminals 3 and 4
(Factory default)
FIGURE 4