Sony SA-40SE1 Manual
17
GB
T
roub
les
hooting/Spec
hooting/Spec
ifications
The STANDBY indicator flashes.
• Turn off the unit and unplug the AC power
cord (mains lead) immediately.
• Remove anything that is blocking the
ventilation hole.
If the unit still does not operate
properly after performing the
above measures, reset the unit
as follows:
properly after performing the
above measures, reset the unit
as follows:
Use the button on the unit for the operation.
1
Press ?/1 to turn on the unit.
2
Hold down ?/1 for 5 seconds.
STANDBY indicator flashes 3 times and
the unit is reset to the default settings.
the unit is reset to the default settings.
Specifications
Amplifier section
AUDIO POWER
SPECIFICATIONS
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(FTC)
(USA model only)
L + R
HARMONIC DISTORTION:
(FTC)
(USA model only)
L + R
With 8 ohm loads, both
channels driven, from 300
– 20,000 Hz; rated 14 watts
per channel minimum
RMS power, with no more
than 1% total harmonic
distortion from 250
milliwatts to rated output.
channels driven, from 300
– 20,000 Hz; rated 14 watts
per channel minimum
RMS power, with no more
than 1% total harmonic
distortion from 250
milliwatts to rated output.
POWER OUTPUT (reference)
L / R
L / R
20 W (per channel at
8 ohms, 1 kHz)
8 ohms, 1 kHz)
(China model only)
POWER OUTPUT (rated)
(Measured under MOVIE sound field)
L + R
POWER OUTPUT (rated)
(Measured under MOVIE sound field)
L + R
9.5 W + 9.5 W
(at 8 ohms, 1 kHz,
1% THD)
(at 8 ohms, 1 kHz,
1% THD)
(Other models)
POWER OUTPUT (rated)
L + R
POWER OUTPUT (rated)
L + R
16 W + 16 W
(at 8 ohms, 1 kHz,
1% THD)
(at 8 ohms, 1 kHz,
1% THD)
POWER OUTPUT (reference)
L / R
L / R
20 W (per channel at
8 ohms, 1 kHz, 10% THD)
8 ohms, 1 kHz, 10% THD)
OTHER
continued