Denon AVR-4806CI User Manual
82
Advanced Operation
Preset memory
1
Press the
MODE SELECTOR
button for the
component you want to preset.
Presetting is not possible for the AMP, ZONE2,
ZONE3, ZONE4, TUNER and SYSTEM CALL modes.
ZONE3, ZONE4, TUNER and SYSTEM CALL modes.
2
Press and hold the
RC SETUP
button for at
least three seconds.
• The top IR segment blinks twice.
3
Referring to the included List of Preset Codes
(
(
End of this manual), press the
NUMBER
button to input the preset code (a 5-digit
number) for
number) for
the manufacturer
of the
component whose signals you want to store in
the memory.
the memory.
• The top IR segment blinks once after each button
press.
• If the remote recognizes the manufacturer’s code,
the IR segment blinks twice.
You have 10 seconds to press each digit. If it takes
longer than that, the remote “times out” and you must
begin again.
longer than that, the remote “times out” and you must
begin again.
3. Tuner system buttons
•
,
ª
: Tuning up/down
BAND
: Switch between AM, FM and XM bands
MODE
: Switch between AUTO and MANUAL
MEM
: Preset memory
SRCH
: RDS search
SFT
: Switch preset channel range
CH +, –
: Preset channel up/down
A ~ G
: Preset channel range
1 ~ 8
: Preset channel
NUMBER
MODE SELECTOR
RC SETUP
IR segment
• The included remote control unit (RC-1036) can be used to
operate devices of different brands by registering the preset
number corresponding to the brand of your device.
number corresponding to the brand of your device.
• For some models the remote control unit or the device may
not operate properly. In this case, use the learning function
(
(
page 85, 86) to store your device’s remote control
signals in the included remote control unit.