Denon AVR-4806CI User Manual
87
Advanced Operation
¢ Using the system call function
1
Press the
AMP
button to select the SYSTEM
CALL mode.
2
Press the
SYSTEM CALL
button (1 to 3) at
which the system call signals have been stored.
• The stored signals are transmitted successively.
Punch Through
• Buttons used in the CD, DVD, and VCR modes can be
assigned to the buttons which are not normally used in the
TV and SAT/CBL modes.
TV and SAT/CBL modes.
• For example, when the DVD mode is set to the punch through
mode in the TV mode, the DVD mode’s PLAY (
1
), STOP (
2
),
MANUAL SEARCH (
6
,
7
), AUTO SEARCH (
8
,
9
)
and PAUSE (
3
) button’s signals are sent in the TV mode. — (
)
1
Press and hold the
RC SETUP
button for at
least three seconds.
• The IR segment blinks twice.
2
Press the
9
,
8
,
4
button (9
→ 8 → 4) to select
punch through setting.
• The IR segment blinks twice.
3
Select the
MODE SELECTOR
button (CD, DVD
or VCR) you want to punch through.
3
Press the
SYSTEM CALL
button (1 to 3) you
want to register the system call.
4
Press the button you want to register.
• The IR segment blinks once after each button press.
The mode can be switched by pressing a MODE
SELECTOR button.
SELECTOR button.
5
Repeat steps 4 to register the desired buttons.
Up to 32 signals each can be stored at the SYSTEM
CALL 1 ~ 3.
CALL 1 ~ 3.
6
Press and hold the
RC SETUP
button for at
least three seconds to register the system call.
• The IR segment blinks twice.
NOTE:
• The remote control signals of the buttons pressed while
• The remote control signals of the buttons pressed while
registering the system call signals are emitted, so be
careful not to operate the components accidentally (cover
the remote sensors, for example).
careful not to operate the components accidentally (cover
the remote sensors, for example).
4
Press the button you want to punch through
(
(
1
,
2
,
6
,
7
,
8
,
9
or 3).
5
Repeat step 4.
6
Press the
MODE SELECTOR
button (TV or
SAT/CBL) for which you want to set the punch
through.
through.
7
Press and hold the
RC SETUP
button for at
least three seconds.
• The IR segment blinks twice.
Setting the back light’s lighting time
1
2
3
Press the
NUMBER
button (
1
to
5
) you want to
adjust the lighting time (5 sec ~ 25 sec).
¢ Lighting time
1 : 5 sec
2 : 10 sec (factory default)
3 : 15 sec
4 : 20 sec
5 : 25 sec
2 : 10 sec (factory default)
3 : 15 sec
4 : 20 sec
5 : 25 sec
• The IR segment blinks twice as confirmation.
Press and hold the
RC SETUP
button for at
least three seconds.
• The IR segment blinks twice.
Press the
9
,
7
,
3
button (9
→ 7 → 3) to select
Light setup.
• The IR segment blinks twice.