JVC CA-DXJ35 User Manual

⁄

 

• When connecting the speaker cords, match their polarity 

with that of the speaker terminals: blue/red to (+) and black 
to (–).

 

• Use only speakers with the same speaker impedance as 

indicated by the speaker terminals on the rear of the System.

• The front speakers and subwoofer(s) are magnetically 

shielded to avoid color distortions on TVs. However, if not 
installed properly, it may cause color distortions. So, pay 
attention to the following when installing the speakers.
– When placing the speakers near a TV set, turn off the 

TV’s main power switch or unplug it before installing the 
speakers.
Then wait at least 30 minutes before turning on the TV’s 
main power switch again.

Some TVs may still be affected even though you have 
followed the above instruction. If this happens, move the 
speakers away from the TV.

@

¤

#

 

Plug the AC power cord to a wall outlet.

Press and hold

Insert

Release

From front right speaker 
(blue/black)

From front left speaker 
(blue/black)

From left subwoofer 
(red/black)

From right subwoofer 
(red/black)

From subwoofer 
(red/black)

From front right 
speaker (blue/black)

From front left speaker 
(blue/black)

From front right speaker 
(red/black)

From front left speaker 
(red/black)

 

• DO NOT connect more than one speaker to 

each terminal.

• DO NOT push or pull the speakers as this 

will damage the foot spacers at the bottom 
of the speakers.

Use a screwdriver to rotate the 
voltage selector so that the voltage 
mark is pointing to the same 
voltage as where you are plugging 
in the unit. (See also the back cover 
page.)

DO NOT plug in before setting the voltage 
selector and all connection procedures are 
completed.

Red

White

Voltage mark

DX-J10_20_30[U].book Page 5 Friday, February 2, 2007 11:25 PM