Korg Speaker System User Manual

Program editing refers to the process of modifying the 
parameters that make up a program to vary the sound 
or to set controllers etc.
General program editing can be performed using the 
performance editor of Program P0: Play, or using the 
REALTIME CONTROLS knobs [1]–[4], but detailed 
editing is performed in Program P1–P9.

Use the parameters of P1–P9 to edit the program that 
you selected in Program P0: Play. In this section we 
will give examples of how to modify representative 
parameters in each page, so that you can understand 
the operation of each parameter. For details on all 
parameters, refer to in the Parameter Guide.

For parameters in P1–P5 that are set indepen-
dently for each oscillator 1 and 2, you can use the 
page menu command “Copy Oscillator” to copy 
settings from one oscillator to the other. This is a 
convenient way to make the same settings for two 
oscillators, or to copy settings from one oscillator 
to the other.

If you wish to save an edited program into internal 
memory, be sure to Write the program. (

If the separately sold EXB-MOSS option is 
installed, you will be able to use the special bank F. 
The parameter structure of bank F programs is dif-
ferent than that of the other banks. Refer to the 
EXB-MOSS owner’s manual.

When P1–P9 are displayed, you can press the [COM-
PARE] to make the LED light. This will recall the 
sound that had been written before you started editing. 
Press the [COMPARE] key once again and the LED will 
go dark, and you will return to the sound that you had 
been editing. Use this function when you wish to com-
pare the unedited sound with the results of your edit-
ing.

When the [COMPARE] key LED is lit, editing a 
parameter will make the LED go dark, and that 
sound will now be the sound that is recalled when 
the [COMPARE] key LED is dark.

In P1: Edit-Basic you can make oscillator-related set-
tings. The TRITON provides two oscillators, and for 
each oscillator you can select a basic waveform (“mul-
tisample

”) and set the pitch. The multisamples pro-

vided by the TRITON include waveforms for musical 
instruments such as pianos, as well as special wave-
forms unique to synthesizers. Multisamples reproduce 
the complex overtone structure and frequency charac-
teristics that allow us to identify a sound as being 
“piano-like” or “guitar-like.”

This sets the mode of the oscillator. Single uses one 
oscillator and Double uses two oscillators. In the case 
of Single the maximum polyphony is 62 notes, and in 
the case of Double the maximum polyphony is 31 
notes. If you wish to use a Drum Kit to create a drums 
program, select Drums.

Select whether the program will sound in Poly (poly-
phonically) or Mono (monophonically). If this is set to 
Poly

, you will be able to play chords using the pro-

gram. If this is set to Mono, only one note will sound 
even if you play a chord. Normally you will set this to 
Poly

, but it is effective to use Mono when you are play-

ing sounds such as analog-synth bass or synth lead. 
Try switching between Poly and Mono, and listen to 
the result.

In this page you can select the multisample for the 
oscillator. The TRITON provides 425 multisamples in 
its internal ROM memory. For the multisample names, 
refer to the separate Voice Name List.
Additional multisamples can be added by installing a 
separately sold EXB-PCM series option board. You can 
also use multisamples from the RAM memory that you 
created in Sampling mode.

The multisample will determine the basic character of 
the program.

●

Multisample
Select