Sony MEX-BT5750U User Manual
8
Preparing the card remote
commander
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 35.
For how to replace the battery, see page 35.
Setting the clock
The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
The setup display appears.
2
Rotate the control dial until “Clock
Adjust” appears.
Adjust” appears.
3
Press the select button.
4
Rotate the control dial to set the hour,
then press the select button.
then press the select button.
5
Rotate the control dial to set the
minute, then press the select button.
To move the digital indication, press (SEEK)
+/–.
The setup is complete and the clock starts.
minute, then press the select button.
To move the digital indication, press (SEEK)
+/–.
The setup is complete and the clock starts.
Detaching the front panel
You can detach the front panel of this unit to
prevent theft.
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OFF).
The unit is turned off.
The unit is turned off.
2
Press (OPEN).
The front panel is flipped down.
The front panel is flipped down.
3
Slide the front panel to the right, then
gently pull out the left end of the front
panel.
gently pull out the left end of the front
panel.
Notes
• Do not drop or put excessive pressure on the front
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
car or on a dashboard/rear tray.
• Do not detach the front panel during playback of the
USB device, otherwise USB data may be damaged.