Cardo Q2 User Manual

2 Wall Chargers

2 Allen Wrenches
2 sets of Velcro Pads

2 MP3 Cables

2 MP3 Cable Holders
2 Glue Plates
2 Pre-moistened Towelettes
2 Carry-Pouches
4 Microphone Sponges 

Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, including Warranty and Registration form

Your headsets are water-resistant, designed for use under moderate 

rain or snow conditions. However, the headsets are not waterproof 

and should not be used under severe weather conditions.

The cover tongue protecting the Charging Jack should be kept tightly 

closed at all times to prevent moisture from entering the device.

NOTE: WHILE MOST INSTRUCTIONS IN THIS MANUAL REFER TO THE HEADSET IN THE 

SINGULAR, THEY APPLY TO BOTH UNITS UNLESS INDICATED OTHERWISE.

Make sure that the headset is fully charged for at least five hours 

before initial use.

1. Connect the wall charger to the headset’s Charging Jack (located 

between the two Volume Buttons).

2. While charging, the Red Light turns on (it may take up to 15 

seconds until the Red Light turns on). When charging is complete, 

the Red Light will turn off.

Pairing is a one time process that is required for mutual recognition be-

tween a headset and other Bluetooth devices. Once the two headsets 

are paired, they will remain paired and automatically recognize each 

other whenever they are within range. The two headsets in your retail 

box are already factory paired and relate to each other as the Primary 

Buddy connection. In addition, each unit can be paired with an addi-

tional scala rider headset for Intercom communication. Please note that 

you can speak via Intercom to one Buddy headset at a time.
NOTE: This Manual refers to the Intercom users and other parties as: 

Primary Buddy and Secondary Buddy.