Cardo Q2 User Manual

3. Search for Bluetooth headsets on your GPS device by following 

the device’s instructions. Please consult your GPS device’s User 

Manual for more information.

4. If your GPS device prompts for a PIN or Passkey enter 0000 (four zeros).

5. Your GPS device will confirm that pairing has succeeded. The 

headset will begin flashing slowly in Blue. 

6. If you wish to use a Bluetooth mobile phone to make and 

receive calls through the headset, you must now pair your 

mobile phone to your GPS device by following your GPS 

and/or mobile phone’s instructions.

NOTE: If the Pairing process is not completed within two 

minutes the headset will return to Standby mode. 

The Helmet Clamp must be attached to the left side of the helmet. 

Once attached, the headset unit can be mounted  or released from 

the Helmet Clamp at any time. If you wish to connect your MP3 player 

to your headset, please refer first to the assembly instructions listed in 

section: USING THE MP3 PLAYER WITH YOUR HEADSET. 

There are two methods that can be used in order to attach the Clamp 

onto the helmet:

Standard Method: Recommended for most helmet types.

Glue Plate Method: Recommended for helmets to 

which the standard method cannot be applied, 

using the Glue Plate included in the box. 

1. Use the enclosed Allen Wrench to loosen the 

two screws on the Back Plate.

2. Slide the Back Plate between the internal 

padding and the external shell of the helmet. 

3. Adjust the clamp’s location so that the 

microphone is located opposite your mouth 

and then tighten the screws. You may need 

to reposition the Clamp repeatedly until you 

identify the best spot. The microphone must 

be positioned vertically and not horizontally. 

phone, please refer to section ATTACHING THE CORDED MICROPHONE 

CLAMP ON A FULL-FACED HELMET

You have the option to glue the Helmet Clamp onto your helmet, 

when the above standard method cannot be used, or in case you 

prefer to secure the Helmet Clamp with adhesive glue. This option 

has been successfully used for a range of high end helmets.

Caution: This process can be done only once! 
1. Use the enclosed Allen Wrench to remove both Allen 

screws and release the Helmet Clamp’s back plate.

2. Determine the location on the helmet where the Hel-

met Clamp must be attached.

3. Adjust the Helmet Clamp’s location on the Helmet so that the 

microphone is located opposite your mouth. You 

may need to reposition the Clamp repeatedly until 

you identify the best spot. The microphone must 

be positioned vertically and not horizontally (Be