GE DHDVH66 User Guide

PROBLEM

Possible Causes

What To Do

Time Remaining

The estimated time may change

• This is normal.

jumped to a

when a smaller load than usual

lower number

is drying

Cannot make a

The DRYNESS LEVEL, TEMP

• This is normal.

selection and the

or OPTION that you are

dryer beeps twice

trying to select is incompatible
with the chosen dry cycle

Dryer is running but

The EXTEND TUMBLE

• This is normal. During extended tumbling, the time

00 is displayed in

option was chosen

remaining is not displayed. The extended tumbling

Time Remaining

option lasts approximately 20 minutes.

Clean Lint Filter (message)

POWER button was activated

• Press START to begin a dry cycle and the message will

disappear.

Dryer doesn’t heat

Fuse is blown/circuit breaker

• Check the building’s fuse/circuit breaker box and

is tripped; the dryer may tumble

replace both fuses or reset both breakers. Your dryer

but not heat

may tumble if only one fuse is blown or one breaker
tripped.

Gas service is off

• Make sure gas shutoff at dryer and main shutoff are

fully open.

LP gas supply tank is empty

• Refill or replace tank. Dryer should heat when utility

or there has been a utility

service is restored.

interruption of natural gas
(gas models)

Inconsistent drying times

Type of heat

• Drying time will vary according to the type of heat used.

If you recently changed from an electric to a gas
(natural or LP) dryer, or vice versa, the drying time
could be different.

Type of load and

• The load size, types of fabric, wetness of clothes and the

drying conditions

length and condition of the exhaust system will affect
drying times.

Glow at the rear

Heaters behind the drum

• This is normal. Under certain drying conditions and

of the drum

room ambient lighting, the glow of the heaters may be
visible at the rear of the drum.

Clothes are still wet

The door was opened mid-cycle. •

A dry cycle must be reselected each time a new load

and dryer shut off

The load was then removed from

is put in.

after a short time

the dryer and a new load put in
without selecting a new cycle

Small load

• When drying 3 items or less, choose SPEED DRY or

TIMED DRY.

Load was already dry except

• Choose SPEED DRY or TIMED DRY to dry damp collars

for collars and waistbands

and waistbands. In the future, when drying a load with
collars and waistbands, choose MORE DRY.

Dryer is not level

• Move dryer to an even floor space or adjust leveling legs

as necessary until even.

Clothes are wrinkled

Overdrying

• Select a shorter drying time.

• Remove items while they still hold a slight amount of

moisture. Select a LESS DRY or DAMP setting.

Letting items sit in dryer after

•Remove items when cycle ends and fold or hang

cycle ends

immediately, or use the EXTEND TUMBLE option.

Overloading

•Separate large loads into smaller ones.

Before you call for service…

Operating Instructions

Safety Instructions

Consumer Support

oubleshooting T

ips