Jensen CD1211 User Manual

CD1211

6

1.

Power Antenna (dark blue wire) - Connect 
to power antenna or amplifier. If not used, 
tape bare end of wire.

2.

Accessory/Ignition (red wire) - Connect to 
existing radio wire or radio fuse.

3.

Ground (black wire) - Connect to ground 
terminal or clean, unpainted part of 
chassis.

4.

Memory/Battery (yellow wire) - Connect to 
battery or 12 volt power source that is 
always live. The radio will not work if this 
wire is not connected.

5.

Antenna Connector - Connect the antenna 
plug from the existing antenna cable 
(some vehicles require an adaptor).

6.

Outputs to Amplifier (gray RCA cables) - 
Connect line out for optional external 
amplifiers. The red connector is for the 
right and the white connector is for the left.

7.

Left Front Speaker

8.

Right Front Speaker 

9.

Left Rear Speaker

10. Right Rear Speaker

When replacing a fuse, make sure the new fuse 
is the correct type and amperage. Using an 
incorrect fuse could damage the radio. The 
CD1211 uses one 15 amp fuse located below 
the wiring connector (15 amp fast blow ATO).

Gray/Black (-)

Gray (+)

White/Black (-)

White (+)

Violet (+)

+

Green (+)

Green/Black (-)

Violet/Black (-)

15