ICOM IC-V85 User Manual

22

5

■

When using a repeater, the transmit frequency is shifted from
the receive frequency by the offset frequency. It is convenient
to program repeater information into memory channels.

q Set the receive frequency (repeater output frequency).
w Push 

and 

(4) several times to select “–” or “+.”

• “–” indicates the transmit frequency is shifted down; “+” indicates

the transmit frequency is shifted up.

• Blinking “–” or “+” indicates the reversed duplex mode is selected

in 

SET MODE

(p. 48).

e Push 

and 

(1) several times to activate the

subaudible tone encoder, if required.

• “ ” appears.
• Select the desired subaudible tone frequency, if necessary. 

(p. 23)

r Push and hold 

to transmit.

• The displayed frequency automatically changes to the transmit

frequency (repeater input frequency).

• If “OFF” appears, check the offset frequency (see next page for

details) and direction.

t Release 

to receive.

y Push and hold 

to check whether the other station’s

transmit signal can be directly received.

■

When the reversed duplex mode is selected, the receive fre-
quency shifts. 

(Transmit frequency shifts in normal duplex mode.)

Each receive and transmit frequency is shown in the table
below with the following conditions;

Input frequency

: 145.30 MHz

Direction

: – (negative)

Offset frequency

: 0.6 MHz

q Push 

, then push 

(8) to enter 

SET MODE

.

w Push 

Y

Y

or 

Z

Z

several times until “REV” appears.

e Rotate 

to turn the reversed duplex mode ON or

OFF.

r Push 

✱

(or 

) to exit 

SET MODE

.

Reversed

OFF

ON 

Rx freq. 145.30 MHz 144.70 MHz

Tx freq. 144.70 MHz 145.30 MHz