ICOM IC-V85-T User Manual

46

10

PAGER/CODE SQUELCH

This display appears when you are called with your ID code
and the calling station’s ID code is 123.

This display appears when you are called with the group
code, 888, and 888 has been programmed into code channel
C6.

When the transceiver receives an incomplete code, “E” and
previously received code appear.

■

When using code squelch you will only receive calls from sta-
tions which know your ID or group code. A 3-digit code is sent
each time 

is pushed in order to open the receiving sta-

tion’s code squelch prior to voice transmission.

q Set the operating frequency.

• Set the volume and squelch to the desired level as in normal op-

eration.

w Push 

, then push 

(0).

• Rotate 

to select “dtm.CS,” if “dtm.PG” or “dtm.OF” ap-

pears.

e Select the desired transmit code channel:

➥ Push and hold 

(0) for 1 sec. to enter code selec-

tion mode.

➥ Rotate 

(or push 

Y

Y

/

Z

Z

) to select the desired

code channel.

➥ Push

✱

(or 

) to exit code selection mode and

return to previous mode.

• 100 MHz digit shows “C.” 

r Operate the transceiver in the normal way (push 

to

transmit; release 

to receive).

t To cancel the code squelch, push 

and 

(0),

then rotate 

to select “dtm.OF.”

• 100 MHz digit shows “1” when the function is cancelled.

Previously received code.

Code channel

“CP” and “    ” blink.

(described on page 20)

To  use these functions in channel number indication, the
pager/code squelch setting must be programmed with other
memory contents before selecting channel number indication.