Kenwood KDC-X494 User Manual

10   |   Quick Start Guide

1

.....1

 

2

.....2

 

3

.....4

 

4

.....4

 

1.  To prevent a short circuit, remove the key 

from the ignition and disconnect the - 
battery.

2.  Make the proper input and output wire 

connections for each unit.

3.  Connect the speaker wires of the wiring 

harness.

4.  Connect the wiring harness wires in the 

following order: ground, battery, ignition.

5.  Connect the wiring harness connector to 

the unit.

6.  Install the unit in your car.
7. Reconnect the - battery.
8.  Press the reset button.

¤

Install this unit in the console of your 
vehicle. 
Do not touch the metal part of this unit 
during and shortly after the use of the 
unit. Metal part such as the heat sink and 
enclosure become hot. 

¤ CAUTION

•  Keep battery out of reach of children 

and in original package until ready to 
use. Dispose of used batteries promptly. 
If swallowed contact physician 
immediately.

•  Do not leave the battery near fire or 

under direct sunlight. A fire, explosion 
or excessive heat generation may result.

•  Do not set the remote control in hot 

places such as on the dashboard.

•  Danger of explosion if Lithium battery is 

incorrectly replaced. Replace only with 
the same or equivalent type.

B59-2005-00_00_KDCX494_K_QSG.indb   10

B59-2005-00_00_KDCX494_K_QSG.indb   10

09/12/18   10:34

09/12/18   10:34