Philips CED1900BT User Manual

Connect wires

Note

•

Make sure that all loose leads are insulated with

electrical tape.

•

Consult a professional to connect wires as instructed

below.

•

Before connection, check the car's wiring carefully.

Connect the ISO male connectors.

ISO male connectors Connect to

1 Green strip, black-

edged green strip

Rear left speaker

2 White strip, black-

edged white strip

Front left speaker

3 Gray strip, black-

edged gray strip

Front right speaker

4 Purple strip, black-

edged purple strip

Rear right speaker

e Red strip

Ignition key +12V

DC when ON/ACC

Blue strip

Motor/electric

antenna relay

control lead

g Blue strip, white strip Amplifier relay

control lead

h Black strip

Ground

Yellow strip

The +12V car

battery which is

energized at all times

Connect other wires if necessary.

Caution

•

To avoid an accident, the driver must not watch video

while driving. By design, this system disallows watching

video during drive. Park your car in a safe place and

engage the parking brake before watching video.

Note

•

When the parking brake of your vehicle is not engaged,

the video blocking system is activated. It blocks the

display of front video source only.

•

If the system is not properly connected with the

parking brake control module of your vehicle, video

signals will be blocked by the system, with the below

message displayed on the TFT.