Sony CDX-F5510 User Manual
17
CDX-F5510/F50M
2-515-314-11 (1)
H:\Data Disk\2515314111\251531411CDXF5510CDXF50MU\01US02CD-U.fm
masterpage:Right
H:\Data Disk\2515314111\251531411CDXF5510CDXF50MU\01US02CD-U.fm
masterpage:Right
Optional accessories/equipment:
Card remote commander: RM-X114
Rotary commander: RM-X4S
Marine remote commander: RM-XM10 (CDX-
F50M only)
Bus cable (supplied with an RCA pin cord):
RC-61 (1 m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T69
MD changer (6 discs): MDX-66XLP
XM Satellite Radio Receiver: XT-XM1
Source selector: XA-C30
AUX-IN selector: XA-300
Rotary commander: RM-X4S
Marine remote commander: RM-XM10 (CDX-
F50M only)
Bus cable (supplied with an RCA pin cord):
RC-61 (1 m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T69
MD changer (6 discs): MDX-66XLP
XM Satellite Radio Receiver: XT-XM1
Source selector: XA-C30
AUX-IN selector: XA-300
Note
This unit cannot be connected to a digital preamplifier
or an equalizer which is Sony BUS system compatible.
This unit cannot be connected to a digital preamplifier
or an equalizer which is Sony BUS system compatible.
Design and specifications are subject to change
without notice.
without notice.
Troubleshooting
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
General
No power is being supplied to the unit.
• Check the connection. If everything is in order,
check the fuse.
• If the unit is turned off and the display
disappears, it cannot be operated with the
remote commander.
t Turn on the unit.
remote commander.
t Turn on the unit.
The power antenna does not extend.
The power antenna does not have a relay box.
US and foreign patents licensed from Dolby
Laboratories.
Laboratories.
• Lead-free solder is used for soldering certain
parts. (more than 80 %)
• Halogenated flame retardants are not used in the
certain printed wiring boards.
• Halogenated flame retardants are not used in
cabinets.
• Packaging cushions do not use polystyrene foam.
No sound.
• The volume is too low.
• The ATT function is activated, or the Telephone
• The ATT function is activated, or the Telephone
ATT function (when the interface cable of a car
telephone is connected to the ATT lead) is
activated.
telephone is connected to the ATT lead) is
activated.
• The position of the fader control (FAD) is not
set for a 2-speaker system.
• The CD changer is incompatible with the disc
format (MP3/ATRAC CD).
t Play back with a Sony MP3 compatible CD
t Play back with a Sony MP3 compatible CD
changer, or this unit.
No beep sound.
• The beep sound is canceled (page 10).
• An optional power amplifier is connected and
• An optional power amplifier is connected and
you are not using the built-in amplifier.
The contents of the memory have been
erased.
erased.
• The RESET button has been pressed.
t Store again into the memory.
• The power connecting lead or battery has been
disconnected.
• The power connecting lead is not connected
properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the
ignition key is switched.
The fuse has blown.
Makes noise when the position of the
ignition key is switched.
The leads are not matched correctly with the
car’s accessory power connector.
car’s accessory power connector.
The display disappears from/does not
appear in the display window.
appear in the display window.
• The dimmer is set “DIM-ON” (page 11).
• The display disappears if you press and hold
• The display disappears if you press and hold
(OFF).
t Press and hold (OFF) again until the
t Press and hold (OFF) again until the
display appears.
• The connectors are dirty (page 15).
DSO does not function.
Depending on the type of car interior or type of
music, DSO may not have a desirable effect.
music, DSO may not have a desirable effect.
CD/MD playback
The disc cannot be loaded.
• Another disc is already loaded.
• The disc has been forcibly inserted upside
• The disc has been forcibly inserted upside
down or in the wrong way.
The disc does not playback.
• Defective or dirty disc.
• The CD-Rs/CD-RWs are not for audio use
• The CD-Rs/CD-RWs are not for audio use
MP3 files cannot be played back.
The disc is incompatible with the MP3 format
and version (page 14).
and version (page 14).
continue to next page
t