Sony XR-C6100R User Manual

Fuse Replacement

When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the
power connection and replace the fuse. If the
fuse blows again after replacement, there may
be an internal malfunction. In such a case,
consult your nearest Sony dealer.

Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as
this could damage the unit.

Cleaning the Connectors

The unit may not function properly if the
connectors between the unit and the front
panel are not clean. In order to prevent this,
open the front panel by pressing (RELEASE),
then detach it and clean the connectors with a
cotton swab dipped in alcohol. Do not apply
too much force. Otherwise, the connectors may
be damaged.

Notes on Cassettes

•

 Do not touch the tape surface of a cassette, as

any dirt or dust will contaminate the heads.

•

 Keep cassettes away from equipment with

built-in magnets such as speakers and
amplifiers, as erasure or distortion on the
recorded tape could occur.

•

 Do not expose cassettes to direct sunlight,

extremely cold temperatures or moisture.

•

 Slack in the tape may cause the tape to be

caught in the machine. Before you insert the
tape, use a pencil or similar object to turn the
reel and take up any slack.

•

 Distorted cassettes and loose labels can cause

problems when inserting or ejecting tapes.
Remove or replace loose labels.

Cassettes longer than 90 minutes
The use of cassettes longer than 90 minutes is
not recommended except for long continuous
play. The tapes used for these cassettes are
very thin and tend to be stretched easily.
Frequent playing and stopping of these tapes
may cause them to be pulled into the cassette
deck mechanism.