Tascam 500b User Manual

Connecting analog audio equipment
Connect the analog inputs of stereo amplifiers, mixers, 

recorders and other analog equipment to this unit’s 

analog output connectors.

Cables are not included with this unit
Using parallel control (CD-500B only)
To use an external controller for parallel control of the 

CD-500B, use the CONTROL I/O PARALLEL connector 

(D-Sub 15-pin). For the pin assignments of the PARALLEL 

connector, see “Using the parallel connector [CD-500B 

only]” on page 32. 

The batteries are not supplied for Taiwan.

Replace both batteries with new ones when the range 

of the remote control becomes short or if the buttons 

become unresponsive.

Misuse of batteries could cause them to leak, rupture or 

otherwise be damaged. Please read and abide by the 

precautions on the battery labels when using them. See 

page 4 of this manual for additional precautions.

When using other devices controlled by infrared rays, 

• 

use of this remote control might operate these devices 

by mistake.
Use the remote control within the following range.

• 

Remote sensor

15° 15°

Directly in front: Within 7 meters

15° left or right: Within 7 meters

Operation of the unit using the remote control can be 

disabled in order to prevent misoperation.
Use the 

15 IR

 menu item to set whether or not the unit 

can be operated by remote control (default value: 

ON

). 

If remote control reception has been set to 

• 

OFF

, 

IR 

OFF

 will appear on the display when any of the remote 

control buttons are pushed.
The remote control reception setting (on/off) is saved 

• 

even if the unit’s power is turned off.