Sony 3-299-319-12 (1) User Manual
16
4
If Passcode* input is required on the
display of the device to be connected,
input “0000.”
display of the device to be connected,
input “0000.”
This unit and the Bluetooth device memorize
each other’s information, and when pairing is
made, the unit is ready for connection to the
device.
each other’s information, and when pairing is
made, the unit is ready for connection to the
device.
“
” flashes and then stays lit after pairing is
complete.
5
Set the Bluetooth device to connect to
this unit.
“
this unit.
“
” or “
” appears when the connection is
made.
* Passcode may be called “passkey,” “PIN code,” “PIN
number” or “Password,” etc., depending on the
device.
device.
Note
Pairing standby mode is not released until the
connection is made.
Pairing standby mode is not released until the
connection is made.
About Bluetooth icons
The following icons are used by this unit.
Connection
If pairing has already been achieved, start
operation from here.
operation from here.
To switch the Bluetooth signal
output of this unit to on
output of this unit to on
To use the Bluetooth function, switch the
Bluetooth signal output of this unit to on.
Bluetooth signal output of this unit to on.
1
Press and hold (BT) until “
” lights
(about 3 seconds).
Bluetooth signal is switched to on.
Bluetooth signal is switched to on.
Connecting a cellular phone
1
Be sure that both this unit and the
cellular phone are switched to
Bluetooth signal on.
cellular phone are switched to
Bluetooth signal on.
2
Connect to this unit using the cellular
phone.
“
phone.
“
”appears when the connection is made.
Connecting the last-connected
cellular phone from this unit
cellular phone from this unit
1 Be sure that both this unit and the cellular
phone are switched to Bluetooth signal on.
2 Press (SOURCE) repeatedly until “BT
PHONE” appears.
3 Press
(handsfree).
“
” flashes while the connection is being
made. And then “
” stays lit when the
connection is made.
Note
While streaming Bluetooth audio, you cannot connect
from this unit to the cellular phone. Connect from the
cellular phone to this unit instead. A connecting noise
may be heard over playback sound.
While streaming Bluetooth audio, you cannot connect
from this unit to the cellular phone. Connect from the
cellular phone to this unit instead. A connecting noise
may be heard over playback sound.
Tip
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone’s specification. If
this unit does not reconnect automatically, connect
manually.
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone’s specification. If
this unit does not reconnect automatically, connect
manually.
lit:
flashing:
off:
flashing:
off:
Bluetooth signal on
Pairing standby mode
Bluetooth signal off
Pairing standby mode
Bluetooth signal off
lit:
flashing:
off:
flashing:
off:
Connection successful
Connecting
No connection
Connecting
No connection
lit:
flashing:
off:
flashing:
off:
Connection successful
Connecting
No connection
Connecting
No connection
XXXX
Input passcode.
“0000”