Sony DSR-80 User Manual
DSR-80
DSR-60
DIGITAL
SDI* (BNC x2, active-through connection)
Conforms to Serial Digital
Interface (270 Mbps),
Interface (270 Mbps),
—
SMPTE 259M
* Using Optional DSBK-120
(SDI Input/Output Board)
SDTI(QSDI) (BNC x1)
Conforms to SDTI (270 Mbps),
SMPTE 259M
SMPTE 259M
—
<AUDIO>
ANALOG
ANALOG
AUDIO
- 9 dBu to 28 dBu,
—
(XLR 3-pin female x4)
600
Ω
/10 k
Ω
, balanced
DIGITAL
AES/EBU 110
Ω
, balanced
—
(XLR 3-pin male x2)
<TIME CODE>
Time Code In* (BNC x1)
0.5 Vp-p to 18 Vp-p, 3 k
Ω
,
unbalanced
—
* Using optional DSBK-130
(Time Code Input/Output Board)
SIGNAL OUTPUTS
<VIDEO>
ANALOG
ANALOG
REF. VIDEO (BNC x1)
Black Burst:
0.286 Vp-p, 75
Ω
, sync negative
Composite Sync*: 2.0 Vp-p, 75
Ω
, sync negative
*When not adding sync to RGB output.
VIDEO 1/2 (SUPER) (BNC x2)
Composite, 1.0 Vp-p, 75
Ω
, sync negative
COMPONENT* (BNC x3)
*selectable
Y/R-Y/B-Y:
Y: 1.0 Vp-p, 75
Ω
, sync negative
R-Y/B-Y: 0.7 Vp-p, 75
Ω
(75 %)
R. G (w/o Sync). B:
0.7 Vp-p, 75
Ω
G (w/Sync):
1.0 Vp-p, 75
Ω
, sync negative
S-Video (DIN 4-pin x1)
Y:
1.0 Vp-p, 75
Ω
, sync negative
C:
0.286 Vp-p, 75
Ω
(at burst level)
DIGITAL
SDI* (BNC x2)
Conforms to Serial Digital Interface (270 Mbps), SMPTE 259M
* Using Optional DSBK-120 (SDI Input/Output Board) for DSR-80,
DSBK-100 (SDI Output Board) for DSR-60
SDTI(QSDI)* (BNC x1)
Conforms to SDTI (270Mbps)
* Using optional DSBK-110 (QSDI Output Board) for DSR-60
<AUDIO>
ANALOG
ANALOG
AUDIO (XLR 3-pin male x4) 4 dBu, 600
Ω
loading, low impedance, balanced
AUDIO MONITOR (RCA phono jack x1) -6 dBu, 47 k
Ω
, unbalanced
HEADPHONES (JM-60 headphone jack x1)
-16 dBu, 8
Ω
, unbalanced
DIGITAL
AES/EBU
2 to 7 Vp-p,110
Ω
, balanced
—
(XLR 3-pin male x2)
<TIME CODE>
Time Code Out* (BNC x1) 2.2 Vp-p, 600
Ω
, unbalanced
* Using optional DSBK-130 (Time Code Input/Output Board)
REMOTE
RS-422A
RS-422A
9-pin multi connector (x1)
TBC
D-sub 15-pin connector (x1)
CONTROL-S (SIRCS)
Stereo mini jack (x1)
SUPPLIED ACCESSORIES
AC power cord (x1), RCC-5G Remote Control Cable (x1)
Operating instructions (x1), ClipLink Guide (x1)
AC power cord (x1), RCC-5G Remote Control Cable (x1)
Operating instructions (x1), ClipLink Guide (x1)
*0dBu = 0.775Vrms
Specifications
DSR-80
DSR-60
GENERAL
Power requirements
AC 100 to 120 V, 50/60 Hz
Power consumption
140 W
85 W
Operating temperature
5 °C to 40 °C (41 °F to 104 °F)
Storage temperature
-20 °C to 60 °C (-4 °F to 140 °F)
Operating humidity
Less than 80 %
Storage humidity
Less than 90 %
Mass
19 kg (41 lb 14 oz)
18 kg (39 lb 10 oz)
Dimensions
427 x 174 x 494 mm excluding external projections
(W x H x D)
(16 7/8 x 6 7/8 x 19 1/2 inches)
Tape speed
28.193 mm/s
Recording/Playback time
Standard size:
More than 184 min. w/PDV-184ME/184N
Mini size:
More than 40 min. w/PDVM-40ME/40N
Fast forward/Rewind time
Standard size: Less than 3 min. w/PDV-184ME/184N
Mini size:
Mini size:
Less than 1 min. w/PDVM-40ME/40N
Search speed
When controlled via RS-422A:
Search speed is up to 32 times,
forward and reverse.
forward and reverse.
When controlled via optional DSRM-10:
JOG mode:
Frame by frame to x2, forward and reverse
SHUTTLE mode:
8 steps, still to x16 normal speed,
forward and reverse
forward and reverse
Digital slow mode:
3 steps, still, x1/5 and x1/10 normal
speed, forward and reverse
speed, forward and reverse
JOG audio mode:
x1/30 to x1, forward and reverse
VIDEO PERFORMANCE
Band width (via analog component I/O)
Luminance:
30 Hz to 5.0 MHz ±1.0 dB
5.75 MHz +0/-3.0 dB (Typical measurement)
5.75 MHz +0/-3.0 dB (Typical measurement)
Chrominance:
30 Hz to 1.5 MHz +1.0/-5.0 dB
S/N ratio (via analog component I/O)
More than 55 dB
K-factor (K2T, KPB)
Less than 2.0 %
Y/C delay
Less than 30 ns
AUDIO PERFORMANCE
Frequency response
2CH mode (48 kHz/16-bit):
20 Hz to 20 kHz +0.5/-1.0 dB
4CH mode (32 kHz/12-bit):
20 Hz to 14.5 kHz +0.5/-1.0 dB
Dynamic range
More than 85 dB
Distortion (THD + N)
Less than 0.05 %
SIGNAL INPUTS
<VIDEO>
ANALOG
ANALOG
REF. VIDEO
Composite, 1.0 Vp-p, 75
Ω
, sync negative
(BNC x2, loop-through connection)
VIDEO
VIDEO
Composite, 1.0 Vp-p, 75
Ω
,
—
(BNC x2, loop-through connection)
sync negative
RGB/COMPONENT* (BNC x3)
*selectable
Y/R-Y/B-Y:
Y: 1.0 Vp-p, 75
Ω
,
—
sync negative
R-Y/B-Y: 0.7 Vp-p, 75
Ω
(75 %)
R. G (w/o Sync). B:
0.7 Vp-p, 75
Ω
—
G (w/Sync):
1.0 Vp-p, 75
Ω
, sync negative
—
S-Video (DIN 4-pin x1)
Y:
1.0 Vp-p, 75
Ω
, sync negative
—
C:
0.286 Vp-p, 75
Ω
(at burst level)
—
Distributed by
©1999 Sony Corporation. All rights reserved.
Reproduction in whole or in part without written permission is prohibited.
Features and specifications are subject to change without notice.
All non-metric weights and measures are approximate.
Sony, Betacam SP, DVCAM, Digital BETACAM, EditStation, i.LINK, QSDI, and ClipLink are registered trademarks of Sony Corporation.
Reproduction in whole or in part without written permission is prohibited.
Features and specifications are subject to change without notice.
All non-metric weights and measures are approximate.
Sony, Betacam SP, DVCAM, Digital BETACAM, EditStation, i.LINK, QSDI, and ClipLink are registered trademarks of Sony Corporation.
MK4197V6TC99MAR
Printed in Japan