Sharp XL-DH350NH User Manual

04/1/28

XL-DH350NH EN.fm

The connection lead is not included. Purchase a 
commercially available lead as shown below.

Auto power on function (AUDIO IN):
When you press any of the following buttons, the unit turns 
on.

Note:
To prevent noise interference, place the unit away from the 
television.

● Do not turn the volume on to full at switch on and listen

to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.

● Before plugging in or unplugging the headphones,

reduce the volume.

● Be sure your headphones have a 3.5 mm (1/8")

diameter plug and impedance between 16 and 50
ohms. The recommended impedance is 32 ohms.

● Plugging in the headphones disconnects the speakers

automatically. Adjust the volume using the VOLUME
control.

Many potential problems can be resolved by the owner 
without calling a service technician.
If something is wrong with this product, check the following 
before calling your authorised SHARP dealer or service 
centre.

● AUDIO IN button on the remote control: The unit turns

on and the “AUDIO IN” function is activated.

●

/  button on the main unit: The unit turns on and

playback of the last function starts (CD, TUNER,
AUDIO IN, USB, iPod).

■ Listening to the playback sounds of 

Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket. When using video
equipment, connect the audio output to this unit and the
video output to a television.

Press the ON/STAND-BY button to turn the power on.

Press the AUDIO IN button on the remote control or
FUNCTION button repeatedly on main unit to select
AUDIO IN function.

Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase
the volume of the connected device.

■ Headphones

XL-DH350

Audio cable
(not supplied)

Portable audio 
player, etc.

■ General

● The clock is not set 

to the correct time.

● Did a power failure occur?

Reset the clock. (Refer 
page 7)

● When a button is 

pressed, the unit 
does not respond.

● Set the unit to the power 

stand-by mode and then 
turn it back on.

● If the unit still malfunctions, 

reset it. (Refer page 21)

● No sound is heard.

● Is the volume level set to 

“0”?

● Are the headphones 

connected?

● Are the speaker wires 

disconnected?

■ CD player

● Playback does not 

start.

● Playback stops in 

the middle or is not 
performed properly.

● Is the disc loaded upside 

down?

● Does the disc satisfy the 

standards?

● Is the disc distorted or 

scratched?

● Playback sounds are 

skipped, or stopped 
in the middle of a 
track.

● Is the unit located near 

excessive vibrations?

● Is the disc very dirty?

● Has condensation formed 

inside the unit?

■ Remote control

● The remote control 

does not operate.

● Is the AC power lead of the 

unit plugged in?

● Is the battery polarity 

correct?

● Are the batteries dead?

● Is the distance or angle 

incorrect?

● Does the remote control 

sensor receive strong 
light?

■ Tuner

● The radio makes 

unusual noises 
continuously.

● Is the unit placed near the 

TV or computer?

● Is the FM aerial or AM loop 

aerial placed properly? 
Move the aerial away from 
the AC power lead if it is 
located nearby.