Alpine iXA-W407 User Manual
22
-EN
MultiInfo Setup Operation
1
Press and hold SETUP of the unit for at least 2
seconds.
seconds.
The SETUP selection screen is displayed.
2
Touch [
] of MultiInfo Setup.
The Multi Info Setup screen appears.
• While in Multi Information mode, you can also recall MULTI INFO
SETUP screen directly by pressing SETUP.
Display example for MULTIINFO SETUP screen
Displays the MultiInfo item selection list.
Displays the selected MultiInfo item. (If no item is
selected, the default items will be displayed.)
Displays the selected MultiInfo item. (If no item is
selected, the default items will be displayed.)
3
Touch [
] or [
] until the desired item is displayed
in the
list.
Setting items:
Clock / Calendar / Calculator / AV Info / AV Cont / Sound Cont. /
IMPRINT
IMPRINT
*
* You can set this item only when an IMPRINT audio processor
(PXA-H100) is connected.
4
Touch the desired item.
(e.g. touch [Calendar])
5
Touch a present item in
that you want to replace.
(e.g. [AV Cont])
The newly-selected item will replace the present one and is
displayed in Multi Information main screen.
(e.g. AV Controller will be replaced as Calendar)
The newly-selected item will replace the present one and is
displayed in Multi Information main screen.
(e.g. AV Controller will be replaced as Calendar)
6
Touch [
] to return to the previous screen.
Touch and hold [
] for at least 2 seconds to return to the
main source screen that was displayed before the setup
operation was started.
operation was started.
• For detailed content and operations of the selected MultiInfo item,
• The selected item in the
list is shown as ineffective (inoperative)
status.
MultiInfo Setup
To display the MultiInfo mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the MultiInfo mode operation has
been released. Engaging the parking brake can reactivate the
MultiInfo mode, as long as the car’s ignition has not been turned
off. It is not necessary to repeat the above procedure (1 through
3) of “To display the MultiInfo mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the MultiInfo mode screen.”
been released. Engaging the parking brake can reactivate the
MultiInfo mode, as long as the car’s ignition has not been turned
off. It is not necessary to repeat the above procedure (1 through
3) of “To display the MultiInfo mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the MultiInfo mode screen.”
The following steps 1 to 6 are common operations to each
“Setting item” of MultiInfo Setup. Refer to each section for
details.
“Setting item” of MultiInfo Setup. Refer to each section for
details.
A
B
A
B
A