JL Audio SB-F-MUCUPE2/13W3v3 User Manual
Continued on Next Page
SB-F-MUCUPE2/13W3v3 INSTR_SKU# 011004
d e t a I l
s t e P 6
From under the vehicle, start the Hex Head Bolt, Split Lock
Washer and Fender Washer (see DETAIL Below) into the
threaded insert in the bottom of the Stealthbox®. do not
From under the vehicle, start the Hex Head Bolt, Split Lock
Washer and Fender Washer (see DETAIL Below) into the
threaded insert in the bottom of the Stealthbox®. do not
tIGHten at tHIs tIme!
s t e P 5
Once the enclosure has been rotated into place, fasten the
included Custom Bracket using the Hex Head Bolt, Split Lock
Washer and Fender Washer as shown on enclosure.
Once the enclosure has been rotated into place, fasten the
included Custom Bracket using the Hex Head Bolt, Split Lock
Washer and Fender Washer as shown on enclosure.
s t e P 4
Set the enclosure into the trunk on the passenger side of
the car, familiarize yourself with the location of the threaded
insert at the front top of the enclosure. Rotate the enclosure
into place.
Set the enclosure into the trunk on the passenger side of
the car, familiarize yourself with the location of the threaded
insert at the front top of the enclosure. Rotate the enclosure
into place.
Page 2 • JL Audio, Inc 2009
S T E P 8
Install hardware as shown through the Bracket and the hole
drilled in
Install hardware as shown through the Bracket and the hole
drilled in
step 7.
S T E P 1 0
C o n G R a t u l a t I o n s !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
amplifier recommendation and basic set-up help.
S T E P 9
Tighten the hardware installed in
Tighten the hardware installed in
step 8 and the hardware
from below the car installed in step 6. Re-install floor cover-
ing, you may need to fold it where the Stealthbox® now sits.
ing, you may need to fold it where the Stealthbox® now sits.
S T E P 7
Push the enclosure back into the side until it is snug in place,
Mark the spot where the bracket lines up with seat brace
structure, drill a 1/2” hole.
Push the enclosure back into the side until it is snug in place,
Mark the spot where the bracket lines up with seat brace
structure, drill a 1/2” hole.
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
tires, transmission lines, electrical wiring, exhaust
systems or anything else that might cause a
reduction in your weekly pay.
always wear eye protection when drilling!
STEALTHBOX WALL
THREADED INSERT
VEHICLE SHEET METAL
FENDER WASHER
LOCK WASHER
HEX BOLT