JL Audio SB-S-LWAG/10W6v2/DG User Manual

SB-S-LWAG/10W6v2_INSTR_SKU#011207

C O N G R A T U L A T I O N S
You have completed the installation for this model!

Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.

S T E P 1 4
Place the wire harness, taillight assembly and trim back into
location.

S T E P 1 3
Look through the pass-through hole and make sure that the
socket cup set screw is lined up with the drilled holes.

With an extra long 3/16-inch hex head wrench, back out the
socket cup set screw to expose about 1 1/2-inch.

The socket cup set screw will wedge itself and secure the
Stealthbox

to the vehicle.

S T E P 1 2
Attach the speaker wire to the terminal on the Stealthbox

and check for proper operation of the woofer.

Place the Stealthbox

into position.

Page 3 • JL Audio, Inc 2006

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.

JLA-SKU#011207-01-22-200

JLA-SKU#011207-01-22-2007

#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at www.jlaudio.com.

(954) 443-1100

w w w . j l a u d i o . c o m

1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A

I N C L U D E D H A R D W A R E

(1)

(1) 3-inch x 3-inch Wax Square

3-inch x 3-inch Wax Square

(1)

(1) 3/8-inch -16 x 2 1/4-inch Socket Cup Screw

3/8-inch -16 x 2 1/4-inch Socket Cup Screw

S P E C I F I C A T I O N S

Enclosure Type: Acoustic Suspension (sealed)

Acoustic Suspension (sealed)

Driver Type: 10W6v2-D4

10W6v2-D4

Nominal Impedance: 2 ohms mono

2 ohms mono

Continuous Power Handling: 400 Watts

400 Watts

P O W E R R E C O M M E N D A T I O N

JL Audio recommends using a high quality amplifier such as the JL Audio 500/1.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1 when
being used to power your Stealthbox

+12VDC

Remote

Ground

JL AUDIO 500/1

five-channel system amplifier

Subwoofer Output

MONO OUTPUT ONLY

120

200

Filter Freq. (Hz)

Mode / Slope

Off / 12dB / 24dB

Amp LP Filter

Infrasonic Freq. (Hz)

Off / 30Hz

Infrasonic Filter

0.5

0.7

1.1

1.6

2.7

4.3

"Q"

Center Freq.

+10

+13

+15

Boost (dB)

Off / On

Bass EQ

Remote Bass Port

Advanced
Bass
Control

Preamp Output Section

Full Range / Amp Filter / Out Filter

Output Mode

Filter Slope

12dB / 24dB

120

200

Filter Freq. (Hz)

Left Ch.

Right Ch.

Filter Mode

LP / HP

Amplifier Input Section

Input Sens.

Left Ch.

Right Ch.

Signal Sensing

Off / On

Input Voltage

Low / High

The JL Audio 500/1 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.

M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 6.5-inch / Front Doors

6.5-inch / Front Doors

Fits JL Audio Models: TR650-CSi, TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi, C5-650, C5-650x &

TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi, C5-650, C5-650x &

ZR650

ZR650-CSi

-CSi

Rear Speaker Size / Location: 5.25-inch / Rear Doors

5.25-inch / Rear Doors

Fits JL Audio Models: TR525-CXi, VR525-CXi, XR525-CXi & C5-525x

TR525-CXi, VR525-CXi, XR525-CXi & C5-525x