JL Audio SB-H-DELSOL/8W6 User Manual
Sheet SKU#011127 Revision 8/8/00
STEP 6: Stuff the
supplied foam-rubber in
both sides of body to
seal off air-flow between
the trunk and the interior
of the car. (This is
critical. If it is not done,
the bass will not sound
good!) Use half of the
supplied material on
each side of the car.
When finished, the foam
should be firmly stuffed
as far back as you can
reach. Note how in the second photo some of the foam even
pokes through the small opening (see arrow).
supplied foam-rubber in
both sides of body to
seal off air-flow between
the trunk and the interior
of the car. (This is
critical. If it is not done,
the bass will not sound
good!) Use half of the
supplied material on
each side of the car.
When finished, the foam
should be firmly stuffed
as far back as you can
reach. Note how in the second photo some of the foam even
pokes through the small opening (see arrow).
STEP 7: Seal small holes in bottom sheet metal with duct tape or
silicone.
silicone.
STEP 8: Reinstall seat belt retractors.
STEP 9: Reinstall rear side trim panels.
STEP 10: Carefully place Stealthbox into position making sure it is
sitting straight and level.
sitting straight and level.
STEP 11: Drill 3/8" Pilot hole through the Stealthbox mounting
holes located behind the carpet flaps on each end of the box.
holes located behind the carpet flaps on each end of the box.
STEP 12: Remove the enclosure and open holes up with 1/2” bit.
STEP 13: Place “U-
nuts” (supplied)through
the stamped factory
holes and over the holes
you have just drilled.
nuts” (supplied)through
the stamped factory
holes and over the holes
you have just drilled.
SB-H-DELSOL/8W6, JL AUDIO, Inc 1996 • Page 2