Phoenix Gold TICS1T Leaflet

Ti Series Tweeter

Instruction Manual - TiCS1T

LIMITED WARRANTY:

Phoenix Gold warrants this product to be free of defects in materials and workmanship for a period of one (1) year from the original date of purchase. This warranty is not transferable and applies only to the

original purchaser from an authorized Phoenix Gold dealer in the United States of America only. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction,

Phoenix Gold will (at its discretion), repair or replace the defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident,

misuse, abuse, product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not cover incidental or

consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not covered under warranty.

INTERNATIONAL WARRANTIES:

Products purchased outside the United States of America are covered only by that country’s Authorized Phoenix Gold reseller and not by Phoenix Gold. Consumers needing service or warranty information

for these products must contact that country’s reseller for information.

FLUSH MOUNT

Each Ti Series component set comes with a flush mount and surface mount

installation kit. The Flush mount requires 3⁄4” depth and a 2-1/16” hole in the

mounting surface. (figure 5)

SURFACE MOUNT

Screws are provided for use when cutting a hole in the door panel or

other mounting surface is not an option. Make sure that the surface

mount location is free of passenger movement that might damage the

tweeter. (figure 6)

- 75w RMS / 150w PEAK Power Handling

- Pivoting Silk Dome Tweeter

- Inline 6dB High Pass Crossover Filter

- Neodymium Motor Structure

- Ferrofluid Cooling Technology

- Surface and Flush Mounting Hardware Included

Important Note: Each tweeter features an inline (capacitor) high pass crossover filter, using the tweeter without this will

damage the tweeter. Each tweeter comes pre-assembled in the flush mount housing, to install the surface mount housing you

will need to temporarily remove the crossover (capacitor). Do not remove this crossover (capacitor) permanently. The one

exception is if the Ti Series Component crossover is being used instead. For example, if a damaged tweeter from the Ti65CS

component system is being replaced then the inline crossover should be removed permanently.

TWEETER ASSEMBLY - FLUSH MOUNT

TWEETER ASSEMBLY - SURFACE MOUNT

FLUSH MOUNT RETAINING RING

Slide the retainer ring over the tweeter

housing onto the inner cup. Rotate the

retainer ring to lock all three pieces into

place.

SURFACE MOUNT RETAINING RING

Slide the retainer ring over the tweeter

housing onto the outer cup. Rotate the

retainer ring to lock all three pieces

into place.

TWEETER HOUSING

INNER CUP

Once you have the inner portion assembled

slide it into the outer cup and twist to lock

into place.

OUTER CUP

OUTER HOUSING

SPRING RETAINER

The spring retainer is what holds the

tweeter in place. Its fingers clamp against

the inside of the wall you are mounting the

tweeter to.