Samson D1800 User Manual

1.  Read these instructions.
2.  Keep these instructions.
3.  Heed all warnings.
4.  Follow all instructions. 
5.  This apparatus shall not be exposed 

to dripping or splashing liquid and 

no object filled with liquid, such as 

a vase, should be placed on the ap-

paratus.

6.  Clean only with a dry cloth.
7.  Do not block any of the ventilation 

openings. Install in accordance with 

the manufacturer's instructions.

8.  Do not install near any heat sources 

such as radiators, heat registers, 

stoves, or other apparatuses (includ-

ing amplifiers) that produce heat.

9.  Only use attachments/accessories 

specified by the manufacturer.

10.  Unplug this apparatus during light-

ning storms or when not in use for 

long periods of time.

11.  Do not override the intended pur-

pose of the polarized or grounding-

type plug. A polarized plug has 

two blades, with one wider than 

the other. A grounding-type plug 

has two blades and a third ground-

ing prong. The wide blade, or third 

prong, is provided for your safety. 

If the provided plug does not fit 

your outlet, consult an electrician to 

replace the obsolete outlet.

12.  Protect the power cord from being 

walked on or pinched, particularly at 

the prongs, convenience receptacles, 

the point where they exit from the 

apparatus.

13.  Use only with the cart 

stand, tripod bracket, 

or table specified by 

the manufacture, or 

sold with the ap-

paratus. When a cart is used, utilize 

caution when moving the cart/ap-

paratus combination to avoid injury 

from tip-over.

14.  Refer all servicing to qualified service 

personnel. Servicing is required if the 

apparatus has been damaged in any 

way, such as power-supply cord or 

plug breakage, damage due to liquid 

or objects falling onto the appara-

tus, exposure to rain or moisture, or 

if the apparatus does not operate 

normally, or has been dropped. 

15.  POWER ON/OFF SWITCH: For prod-

ucts with a power switch, the power 

switch DOES NOT break the connec-

tion from the mains.

16.  MAINS DISCONNECT: The plug 

should remain readily operable. 

For rack-mount or installation 

where plug is not accessible, an 

all-pole mains switch with a contact 

separation of at least 3 mm in each 

pole shall be incorporated into the 

electrical installation of the rack or 

building.

17.  FOR UNITS EQUIPPED WITH EXTER-

NALLY ACCESSIBLE FUSE RECEP-

TACLE: Replace fuse with same type 

and rating only.

18.  MULTIPLE-INPUT VOLTAGE: This 

equipment may require the use of a 

different line cord, attachment plug, 

or both, depending on the available 

power source at installation. Connect 

this equipment only to the power 

source indicated on the equipment 

rear panel. To reduce the risk of fire 

or electric shock, refer servicing 

to qualified service personnel or 

equivalent.