Bogen 2233R User Manual
11
Rated Output:
B Program – 1.8V into Hi-Z load (line out to booster)
Note: The output is unbalanced; nominal output impedance is 5.6 kilohms
Note: The output is unbalanced; nominal output impedance is 5.6 kilohms
Frequency Response (at rated output)
B Program – MIC Inputs: Shaped for maximum intelligibility (-3 dB @ 300 Hz
and 15 kHz);
and 15 kHz);
AUX Input: +1, -3 dB from 80 Hz to 15 kHz
Distortion
Less than 1% @ Rated Power and Bandwidth
Input Sensitivity
B Program – MIC Inputs: 300µV balanced Lo-Z for rated output:
AUX Input: 100mV unbalanced Hi-Z for rated output
AUX Input: 100mV unbalanced Hi-Z for rated output
Signal-to-Noise Ratio
B Program – MIC Inputs: 60 dB below rated output:
AUX Input: 80 dB below rated output
AUX Input: 80 dB below rated output
Controls/Indicators :
Input Gain (rear panel):
MIC1, MIC2, AUX
Program Selection:
MIC1, MIC2, AUX
Monitor:
Two-position switch selects program channel for monitoring from MCP35A
Program:
Adjusts Channel B program level
B
Program Level:
LED Indicators (N - normal, P - peak, O - overload)
Dimensions:
19" W x 1-3/4" H x 10" D
Technical Specifications
Phantom Power
Phantom Power may be enabled for MIC1 or MIC2 by connecting pins 2 and 3 on the printed circuit board
shunts labeled J1 and J2, respectively.
shunts labeled J1 and J2, respectively.
MIC
1 Monitor Mute
If the MCP35A console microphone is connected to the MCPB MIC1 input, move the shunt labeled J3 (on
MCPB) to the ON position.
MCPB) to the ON position.
Figure 7 - Wiring Diagram, Typical MCPB Interconnection