Novatel DL-V3 User Manual
178
DL-V3 User Manual Rev 3
Appendix D
Ethernet Configuration
This section details the ethernet configuration for the DL-V3 including automatic Ethernet
configuration on start-up.
configuration on start-up.
On power-up, or after a FRESET command, the DL-V3 automatically configures the Ethernet device.
This configuration includes the following settings:
This configuration includes the following settings:
•
Static IP address: 192.168.1.223
•
Subnet mask: 255.255.255.0
•
Ethernet Line 1 speed: 115 200 bps
If the receiver is turned off, or power is removed, the Ethernet or Bluetooth mode on COM3 is
returned to whichever mode was applied before power-down when it is powered up again. When you
issue a FRESET command, COM3 defaults to Bluetooth mode.
returned to whichever mode was applied before power-down when it is powered up again. When you
issue a FRESET command, COM3 defaults to Bluetooth mode.
D.1
Physical Set-Up
Below are the configuration methods described in this section and the hardware you require to set
them up:
them up:
•
Configuration Via Network Cable
-
DL-V3 with power cable and serial communications cable
-
User-supplied laptop with an available Ethernet port, serial port (or USB port with
NovAtel serial to USB drivers) and the Lantronix software, described below, installed
NovAtel serial to USB drivers) and the Lantronix software, described below, installed
-
Sheilded CAT5 Ethernet cross-over cable (or use a switch with a straight through
Ethernet cable)
Ethernet cable)
•
Configuration Via Serial and Network Parameters
-
DL-V3 with power cable
-
User-supplied laptop with the Lantronix software, described below, installed
-
Serial null-modem cable to connect from the laptop and switch between COM1 and
COM2 on the DL-V3. You can avoid switching if you have two serial connections on
your laptop and two null-modem cables. Also, if your laptop has only USB connectors,
you need a USB to serial adaptor between the null-modem cable and the laptop’s USB
connector.
COM2 on the DL-V3. You can avoid switching if you have two serial connections on
your laptop and two null-modem cables. Also, if your laptop has only USB connectors,
you need a USB to serial adaptor between the null-modem cable and the laptop’s USB
connector.
-
Sheilded CAT5 Ethernet cross-over cable (or use a switch with a straight through
Ethernet cable)
Ethernet cable)
In both cases, first install the Com Port Redirector (CPR) Manager program onto the laptop you
intend to use with your DL-V3 from the Lantronix website at:
intend to use with your DL-V3 from the Lantronix website at:
Figure 39 below shows the two methods of physically providing an Ethernet connection between your
laptop and DL-V3. The top shows a direct connection using a sheilded CAT5 Ethernet cross-over
cable and the bottom shows two straight-through sheilded CAT5 Ethernet cables with a DSS-5+ port
laptop and DL-V3. The top shows a direct connection using a sheilded CAT5 Ethernet cross-over
cable and the bottom shows two straight-through sheilded CAT5 Ethernet cables with a DSS-5+ port