Novatel DL-V3 User Manual
DL-V3 User Manual Rev 3
25
Chapter 2
Installation and Setup
This chapter contains instructions and tips to set up your DL-V3 to create a GNSS receiver system.
2.1
Additional Equipment Required
In order for the receiver to perform optimally, the following additional equipment is required:
•
A NovAtel GNSS antenna (user-supplied, NovAtel recommended)
•
A quality coaxial cable, and interconnect adapter cable as necessary (user-supplied)
•
A PC/laptop (user-supplied)
•
A means of communicating between the DL-V3 and PC/laptop
•
Serial null-modem cable (included with the receiver, NovAtel part number
01017658), see Figure 8, DB-9 Setup on Page 28
01017658), see Figure 8, DB-9 Setup on Page 28
•
USB cable (user-supplied), see Figure 9, USB Setup on Page 28
•
Ethernet crossover cable (user-supplied), see Figure 11, Ethernet Setup on Page 29
•
Bluetooth link (user-supplied), see Figure 10, Bluetooth Setup on Page 29
Use a serial COM or USB connection to communicate with the receiver
first. This will give you the ability to configure the PC/laptop and DL-V3
before Ethernet or Bluetooth use.
first. This will give you the ability to configure the PC/laptop and DL-V3
before Ethernet or Bluetooth use.
•
A power supply (user-supplied)
•
A power cable (included with the receiver)
CAUTION:
When the DL-V3 is installed in a permanent location, such as in a building, it
should be protected by a lightning protection device according to local building
codes. See also Warranty on Page 15.
should be protected by a lightning protection device according to local building
codes. See also Warranty on Page 15.
2.1.1
DL-V3 Setup
Complete the steps below to connect and power your DL-V3. See also Figures 8 to 11 starting on
Page 28.
Page 28.
1.
Mount a GNSS antenna on a secure, stable structure with an unobstructed view of the sky from
horizon to horizon, see Section 2.1.7, Mounting the GNSS Antenna on Page 32.
horizon to horizon, see Section 2.1.7, Mounting the GNSS Antenna on Page 32.
2.
Ensure a CF card is in the slot behind the door on the front face of the DL-V3. Open, or secure,
the door by turning the latch. See also Section 2.2.6, DL-V3 Removable Compact Flash Memory
Card starting on Page 39.
the door by turning the latch. See also Section 2.2.6, DL-V3 Removable Compact Flash Memory
Card starting on Page 39.
Once the CF card is installed, ensure that it is properly formatted, see
Page 39.
Page 39.