Novatel DL-V3 User Manual
94
DL-V3 User Manual Rev 3
B.9
FRESET
Clear Selected Data from NVM and Reset
The OEMV freset command is extended to include DL-V3 features. An additional target field,
userdata (value = 10), resets only the DL-V3 user data NVM, thereby resetting all parameters
indicated in this document as “Stored in NVM” to factory defaults. Issuing the freset command with
the “target” field set to standard, resets the userdata NVM as well as OEMV parameters as indicated
in the OEMV Family Firmware Reference Manual.
userdata (value = 10), resets only the DL-V3 user data NVM, thereby resetting all parameters
indicated in this document as “Stored in NVM” to factory defaults. Issuing the freset command with
the “target” field set to standard, resets the userdata NVM as well as OEMV parameters as indicated
in the OEMV Family Firmware Reference Manual.
The DL-V3 factory default command list is on Page 96.
If you issue the FRESET command without any parameters, it is the same as issuing a FRESET
STANDARD command.
Table 24: FRESET Target
Fiel
d
Field
Type
Type
ASCII
Value
Value
Binar
y
Value
Description
Binary
Forma
t
Binar
y
Bytes
Binar
y
Offset
1
FRESET
header
header
-
-
This field contains the command name
or the message header depending on
whether the command is abbreviated
ASCII, ASCII or binary, respectively.
or the message header depending on
whether the command is abbreviated
ASCII, ASCII or binary, respectively.
-
H
0
2
target
See Table 24
Data to be reset by the receiver
Enum
4
H
Binary
ASCII
Description
0
STANDARD
Resets commands, ephemeris, and almanac (default). Also resets all L-
band related data except for subscription information.
band related data except for subscription information.
1
COMMAND
Resets the stored commands (saved configuration)
2
GPSALMANAC
Resets the stored GPS almanac
3
GPSEPHEM
Resets the stored GPS ephemeris
4
GLOEPHEM
Resets the stored GLONASS ephemeris
5
MODEL
Resets the currently selected model
10
USERDATA
Reset DL-V3-only commands
11
CLKCALIBRATION
Resets the parameters entered using the CLOCKCALIBRATE command
20
SBASALMANAC
Resets the stored SBAS almanac
21
LAST_POSITION
Resets the position using the last stored position
31
GLOALMANAC
Resets the stored GLONASS almanac