Hitachi L37VP01E User Manual

Page of 44
English   - 11 -
Handling the Remote Control
• It could cause corrosion or battery leakage and may
result in physical injury and/or property damage in-
cluding fire.
• Never mix used and new batteries in the device.
• Replace all the batteries in a device at the same time.
•  Remove  the  batteries  if  the  remote  control  is  not
going to be used for an extended period of time.
• To avoid possible failure, read the following instruc-
tions and handle the remote control properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
•  Do  not  place  the  remote  control  under  the  direct
sunlight or near sources of excessive heat.
NOTE:  Remove  the  battery  from  remote  control
handset when it is not to be used for a long
period. Otherwise it can be damaged due
to any leakage of battery.
Operating Range for the Remote Control
• Point the top of the remote control toward the LCD
TV's remote sensor LED while pressing a button.
Remote range is approximately 7m/23ft.
Preparation
For ventilation, leave a space of at least 10 cm free all
around the set. To prevent any fault and unsafe situ-
ations, please do not place any objects on top of the
set.
Use this apparatus in moderate climates.
Before Switching On Your TV
Power Connection
IMPORTANT: The TV set is designed to operate on
220-240 AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambi-
ent room temperature before you connect the set to
the mains.
Connections To The Aerial Input Socket
• Connect the aerial or cable TV plug to the Aerial input
socket located at the rear of the TV and connect the
cable plug coming out from the TV out socket lo-
cated on the devices (VCR, DVB etc.) to this socket
as  well.
Inserting Batteries In The Remote
Control Handset
WARNING  :
Remote  control  is  battery  included.
A  plastic  protector  is  used  to  dis-
connect the batteries in order to pre-
vent  the  battery  life  from  reducing.
Please remove the plastic protector
before the first use.
• Remove the battery cover located on the back of the
handset by gently pulling backwards from the indi-
cated part.
• Insert two AA/R06 or equivalent type batteries in-
side. Place the batteries in the right directions and
replace the battery cover.