Orion Car Audio HCCA10002 User Manual
© 2009 Directed Electronics. All rights reserved.
3
END PANEL LAYOUTS
HCCA10002
ESP
REMOTE
GAIN
L
INPUT
R
INPUT
L
OUTPUT
R
OUTPUT
L CH
R CH
1
2
3
4
6
5
BRIDGE 4 OHM
HCCA10004
6
1
7
8
4
9
10
11
12 13
ESP
RF
R
RR
LF
INPUT
GAIN
RANGE
CH
MODE
LINE
OUT
L
OUTPUT
LR
INPUT
LF
RF
LR
RR
HIGH
LOW
LOW
2 CH
4 CH
4 CH
F/R SUM
PASS
PASS
REMOTE
GAIN
BRIDGE 4 OHM
BRIDGE 4 OHM
ESP
1.
- Allows connection of a Directed ESP controller, like the
Bitwriter.
Speakers
2.
(Left channel)
(HCCA10002 only, refer to the Speaker Connections section of
this guide.)
this guide.)
Input -
3.
Accepts RCA input from a head unit, preamplifier, or
equalizer (HCCA10002 only).
RCA Line Output -
4.
Provides easy connection to additional ampli-
fiers, the RCA inputs and RCA output are the same signal and are
not affected by any amplifier functions.
not affected by any amplifier functions.
Speakers
5.
(right channel) - HCCA10002 only see item 2
Remote Gain Input -
6.
Connects optional RGC2 remote gain control
to control the gain level from the driver’s seat.
GAIN RANGE -
7.
Selects the input sensitivity range to either High
(for high power head units) or Low (for line level head units).
Speakers
8.
(Left Front and Right Front below)
ers to these terminals. (HCCA10004 only, refer to the Speaker
Connections section of this guide.)
Connections section of this guide.)
Input
9.
(Left Front and Right Front below) - Accepts RCA input from
a head unit, preamplifier, or equalizer (HCCA10004 only).
Input
10.
(Left Rear and Right Rear below) - see item 9
Speakers
11.
(Right Rear and Left Rear below)
2/4 Channel Switch -
12.
2ch setting will allow 4 channel output with
a signal only present on the front inputs. 4 ch will allow a 4 chan-
nel output when signal is present on the front and rear inputs.
nel output when signal is present on the front and rear inputs.
Front/Rear Sum Switch -
13.
Allows you to sum the front and rear
channels together before sending the signal out the RCA line out.
If the switch is not engaged, then only the front left and front
right signals are sent to the RCA line out.
If the switch is not engaged, then only the front left and front
right signals are sent to the RCA line out.
Figure 1
Figura 1
Figura 1
Abbildung 1
Figure 2
Figura 2
Figura 2
Abbildung 2