Panasonic CQ-C1305U User Manual

 Keep the sound volume at an appropriate level.

Keep the volume level low enough to be aware of road and traffi c 
conditions while driving.

 This unit is designed for use exclusively in automobiles.
 Do not operate the unit for a prolonged period with the 

Operating the audio system for a long period of time with the 
engine turned off will drain the battery.

 Do not expose the unit to direct sunlight or excessive 

Otherwise these will raise the interior temperature of the unit, and 
it may lead to smoke, fi re, or other damage to the unit.

 Do not use the product where it is exposed to water, 

Exposure of the unit to water, moisture, or dust may lead to 
smoke, fi re, or other damage to the unit. Make especially sure that 
the unit does not get wet in car washes or on rainy days. 

 Set the volume level to low enough before the AUX 

Failure to observe this, the loud noise may come out and damage 
your speakers and your hearing. Direct connection of the speaker/
headphone output of an external device without any attenuator 
may distort sound or damage the connected external device.

 Refer wiring and installation to qualifi ed service 

Installation of this unit requires special skills and experience. For 
maximum safety, have it installed by your dealer. Panasonic is not 
liable for any problems resulting from your own installation of the 
unit.

 Follow the instructions to install and wire the product.

Not following the instructions to properly install and wire the 
product could cause an accident or fi re.

 Take care not to damage the leads.

When wiring, take care not to damage the leads. Prevent them 
from getting caught in the vehicle chassis, screws, and moving 
parts such as seat rails. Do not scratch, pull, bend or twist the 
leads. Do not run them near heat sources or place heavy objects 
on them. If leads must be run over sharp metal edges, protect the 
leads by winding them with vinyl tape or similar protection.

 Use the designated parts and tools for installation.

Use the supplied or designated parts and appropriate tools to 
install the product. The use of parts other than those supplied 
or designated may result in internal damage to the unit. Faulty 
installation may lead to an accident, a malfunction or fi re.

 Do not block the air vent or the cooling plate of the unit.

Blocking these parts will cause the interior of the unit to overheat 
and will result in fi re or other damage.

 Do not install the product where it is exposed to strong 

Avoid slanted or strongly curved surfaces for installation. If the 
installation is not stable, the unit may fall down while driving and 
this can lead to an accident or injury.

 Installation  Angle

The product should be installed in a horizontal position with the 
front end up at a convenient angle, but not more than 30˚.
The user should bear in mind that in some areas there may be 
restrictions on how and where this unit must be installed. Consult 
your dealer for further details.

 Wear gloves for safety. Make sure that wiring is 

 To prevent damage to the unit, do not connect the power 

 Do not connect more than one speaker to one set of 

• Use only specifi ed battery (CR2025).
• Match the polarity of the battery with the (+) and (–) marks in the 

battery case.

• Replace a dead battery as soon as possible.
• Remove the battery from the remote control unit when not using it 

for an extended period of time.

• Insulate the battery (by placing them in a plastic bag or covering 

them with vinyl tape) before disposal or storage.

• Dispose of the battery according to the local regulations.
• Do not disassemble, recharge, heat or short the battery. Do not 

throw a battery into a fi re or water.

• Thoroughly wipe the battery liquid off the battery case and insert 

new battery.

• If any part of your body or clothing comes into contact with 

battery liquid, wash it with plenty of water.

• If battery liquid comes into contact with your eyes, wash them 

with plenty of water and get immediate medical attention.

THIS PRODUCT IS A CLASS I LASER PRODUCT.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF 
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY 
RESULT IN HAZARDOUS RADIATION EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR BY YOURSELF.
REFER SERVICING TO QUALIFIED PERSONNEL.

FCC Warning:
Any unauthorized changes or modifi cations to this equipment 
would void the user’s authority to operate this device.

Notice
This product contains a CR Coin Cell Lithium Battery which 
contains Perchlorate Material - special handling may apply. 
See www.dtsc.ca.gov/hazardouswaste/perchlorate.