ONKYO CR-325UKD User Manual

Page of 64
41
Listening to the Radio
When tuned into a station, the Tuned 
 indicator 
appears. When tuned into a stereo FM station, the FM ST 
indicator appears as well.
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to 
Manual Tuning mode and listen to the station in mono.
Adjusting the Antennas
Tuning into AM/FM Radio Stations
1
Press the [BAND] button repeat-
edly to select “AM” or “FM”.
YES/MODE
BAND
(     TUN/
TUN     )
    /      
AUTO
FM ST
Band
Frequency
2
Press the [YES/MODE] button 
repeatedly to select “Auto” or 
“Manual”.
• Auto Tuning Mode
The AUTO indicator appears and ste-
reo radio reception is possible.
• Manual Tuning Mode
The AUTO indicator is not displayed 
and radio reception will be in mono.
3
Use the Rewind and Fast Forward 
[
5]/[4] buttons to tune into a 
station.
In Auto tuning mode,
 once a station is 
found, tuning stops automatically.
Radio Frequency can be changed in 0.05 
MHz steps for FM and 9 kHz or 10 kHz 
steps for AM.
In Manual Tuning mode, the frequency 
stops changing when you release the but-
ton. Press the button repeatedly to 
change the frequency one step at a time.
Note:
On the CD receiver, you can also tune into 
a station by pressing its PRESET 
[
t]/[1] button for a few seconds.
AUTO indicator
1
2
Change the direction of the 
antenna to achieve the best 
reception.
Affix the antenna with a thumbtack. (Do not 
push the thumbtack through the antenna.)
Caution: 
Be careful not to prick your finger!
Adjusting the AM antenna
Adjust the location and position of the AM 
antenna while listening to an AM station to 
achieve the best reception.
Adjusting and installing the FM antenna
Choose a location for the FM antenna while listening to an FM station.