ONKYO CR-325UKD User Manual

6

In general, the illustrations in this Instruction Manual show the CR-425UKD/CR-325UKD.

• If the remote controller doesn’t work reliably, try replac-

ing the batteries.

• Don’t mix new and old batteries or different types of bat-

teries.

• If you intend not to use the remote controller for a long 

time, remove the batteries to prevent damage from leak-
age or corrosion.

• Expired batteries should be removed as soon as possible 

to prevent damage from leakage or corrosion.

When you operate the remote controller, point it at the 
CD receiver’s remote control sensor, as shown below.

• The remote controller may not work reliably if the CD 

receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in mind 
when installing.

• If another remote controller of the same type is used in 

the same room, or the CD receiver is installed close to 
equipment that uses infrared rays, the remote controller 
may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller because the buttons may be pressed inadvertently, 
thereby draining the batteries.

• The remote controller may not work reliably if the CD 

receiver is installed in a rack behind colored glass doors. 
Keep this in mind when installing.

• The remote controller will not work if there’s an obstacle 

between it and the CD receiver’s remote control sensor.

Insert two batteries (R6/AA) into the bat-
tery compartment.
Carefully follow the polarity diagram (positive 
(+) and negative (–) symbols) inside the battery 
compartment.

Ap

pro

x. 

5 m

Remote control sensor

CD receiver