First Alert K5309-5V2 User Manual
– 16 –
$UPLQJWKH6\VWHP
$UPLQJ&RPPDQGV
Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.
message is displayed.
Modes of Arming
Mode
Press these keys…
Keypad Confirms By…
Stay
security code + [3] (STAY)
• three beeps
†
• armed STAY message displayed
• red ARMED indicator lights
Night-Stay
security code + [3] + [3]
• three beeps
†
• NIGHT-STAY message displayed
• red ARMED indicator lights
Instant
security code + [7] (INSTANT)
• three beeps
†
• armed STAY message displayed
• red ARMED indicator lights
• also note that entry delay is turned off.
Away
security code + [2] (AWAY)
• two beeps
†
, or, if programmed, beeping for
duration of exit delay
• armed AWAY message displayed
• red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The keypad beeps rapidly
during the last 10 seconds of the exit delay
to warn you that it is ending.
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The keypad beeps rapidly
during the last 10 seconds of the exit delay
to warn you that it is ending.
Maximum
security code + [4] (MAXIMUM)
• same as Away (described above)
Note that entry delay is turned off.
Note that entry delay is turned off.
† Arming Ding: In addition to the keypad beeps, the external sounder emits a short “ding” sound after
arming, if programmed to do so. The ding confirms that the system is armed, and may occur immediately
after the command or be delayed (until arm/disarm report is sent or exit delay expires). Ask your installer
about how this feature is set for your system.
arming, if programmed to do so. The ding confirms that the system is armed, and may occur immediately
after the command or be delayed (until arm/disarm report is sent or exit delay expires). Ask your installer
about how this feature is set for your system.
Quick Arming
If "Quick Arming" was programmed by the installer, the
If "Quick Arming" was programmed by the installer, the
[#]
key can be pressed in place
of the security code when arming the system in any of its arming modes (except Night-
Stay). However, the security code must always be used to disarm the system.
Stay). However, the security code must always be used to disarm the system.
Function Key Arming
For any arming command, a function key may have also been programmed for your
system. If so, you can press and hold the appropriate function key for 2 seconds to arm
the system. See your installer for the designated functions (see Single Button
Arming section).
For any arming command, a function key may have also been programmed for your
system. If so, you can press and hold the appropriate function key for 2 seconds to arm
the system. See your installer for the designated functions (see Single Button
Arming section).
Refer to the Accessing Other Partitions section for information on multi-partition
arming (FA168CPS).
arming (FA168CPS).