Sony 3-869-888-16 (1) User Manual
133
Chapter 5 Settings
Action
Select the type of action to perform upon triggering from the pull-down list.
Select from [Report By Mail], [Start Beep], [Stop Beep], [Change Monitor
Layout], [Activate Alarm Out], [Deactivate Alarm Out], and [Recall
Preset].
The settings that appear subsequently vary depending on the action you
select here.
Select the type of action to perform upon triggering from the pull-down list.
Select from [Report By Mail], [Start Beep], [Stop Beep], [Change Monitor
Layout], [Activate Alarm Out], [Deactivate Alarm Out], and [Recall
Preset].
The settings that appear subsequently vary depending on the action you
select here.
• When [Report By Mail] is selected
You can select whether to send a still image attachment in response to a
trigger. When there is an event such as a hardware failure or system error,
basic information about the error is included in the body text of the
message.
trigger. When there is an event such as a hardware failure or system error,
basic information about the error is included in the body text of the
message.
E-Mail (SMTP)
The recipient cannot be set here. Use “e-Mail” on the General screen
to enter a recipient address.
The recipient cannot be set here. Use “e-Mail” on the General screen
to enter a recipient address.
Caution
Configure the e-mail settings before configuring actions. If you
modify the e-mail settings after configuring an action, you need to
resave the corresponding action for the new settings to take effect.
modify the e-mail settings after configuring an action, you need to
resave the corresponding action for the new settings to take effect.
Send Still Image
Select this check box to send a still image attached to the message.
However, when a still image cannot be generated, no still image is
attached to the message sent even if this check box is selected.
Select this check box to send a still image attached to the message.
However, when a still image cannot be generated, no still image is
attached to the message sent even if this check box is selected.
Camera
Select the camera to capture the still image.
Select the camera to capture the still image.
• When [Start Beep] is selected
Duration (sec)
Specify the length of the beep in seconds.
Specify the length of the beep in seconds.