JAI CV-L105 User Manual
CV-L105
6.3. Other functions
6.3.1. Binnig
Binning is a function where the signal from two neighbour pixels are added and read out as a
single pixel. The sensitivity will be double, but the resolution will be the half. The binning
function has no influence on the internal scan rate and shutter setting.
The function can be selected by RS-232C, internal jumper setting or on the I/F connector pin
Binning is a function where the signal from two neighbour pixels are added and read out as a
single pixel. The sensitivity will be double, but the resolution will be the half. The binning
function has no influence on the internal scan rate and shutter setting.
The function can be selected by RS-232C, internal jumper setting or on the I/F connector pin
#10.
For configuration please refer to 7.2 and 7.3.
For configuration please refer to 7.2 and 7.3.
6.3.2. Pixel rate
The camera has 2 pixel clock frequencies, 30 MHz and 15 MHz. The pixel rate function selects
the pixel clock for the data read out. The function has no influence on the internal scan rate and
shutter setting. The max. scan rate with external trigger depends of the pixel clock.
The function can be selected by RS-232C, internal jumpers or on the I/F connector pin #31.
The camera has 2 pixel clock frequencies, 30 MHz and 15 MHz. The pixel rate function selects
the pixel clock for the data read out. The function has no influence on the internal scan rate and
shutter setting. The max. scan rate with external trigger depends of the pixel clock.
The function can be selected by RS-232C, internal jumpers or on the I/F connector pin #31.
For configuration please refer to 7.2 and 7.3.
6.3.3. RS-232C on/off
This function makes it possible to disable the RS-232C input. It is useful when the camera is
operated in an environment with RFI fields are present. When RS-232C is disabled, the binning
and pixel rate can be changed by inputs on the I/F connector.
The function can be selected by internal jumpers or on the I/F connector pin #30.
For configuration please refer to 7.2 and 7.3.
This function makes it possible to disable the RS-232C input. It is useful when the camera is
operated in an environment with RFI fields are present. When RS-232C is disabled, the binning
and pixel rate can be changed by inputs on the I/F connector.
The function can be selected by internal jumpers or on the I/F connector pin #30.
For configuration please refer to 7.2 and 7.3.
6.3.4. Offset and Gain
Inside the camera there are potentiometers to adjust red, green and blue offset and gain.
They are used for the factory setting of the color balance. This is done for 3100K color
temperature. Other adjustments can be done with the potentiometers. It is not recommended to
torch the green gain and offset potentiometer, as they are the reference.
The adjustment is only for the factory setting. It has no function in the 4 user defined camera
configurations and settings.
Inside the camera there are potentiometers to adjust red, green and blue offset and gain.
They are used for the factory setting of the color balance. This is done for 3100K color
temperature. Other adjustments can be done with the potentiometers. It is not recommended to
torch the green gain and offset potentiometer, as they are the reference.
The adjustment is only for the factory setting. It has no function in the 4 user defined camera
configurations and settings.
6.3.5. LED on rear
On the camera rear two LED indicators are found. The LED marked POWER will indicate that the
power supply is on. The lower LED marked BUSY will light when external trigger is applied.
On the camera rear two LED indicators are found. The LED marked POWER will indicate that the
power supply is on. The lower LED marked BUSY will light when external trigger is applied.
- 14 -