Lucent Technologies 8.2 User Manual
DEFINITY ECS Release 8.2
Administrator’s Guide
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
1013
Trunk Group
17
Ringing Monitor (msec)
This timer is sent to TN464C (or later), TN767, TN438 (all), TN447, TN465 (all),
TN2138, TN2147, TN2184, and TN2199 CO circuit packs.
TN2138, TN2147, TN2184, and TN2199 CO circuit packs.
Cama Wink Start Time (msec)
Incoming Partial Dial (sec)
This timer appears only if the Incoming Dial Type field is
rotary
.
NOTE:
This timer is never sent to TN429 ports.
Incoming Seizure (msec)
This field appears when the Direction field is
incoming
or
two-way,
and, when
applicable, the Trunk Signaling Type field is
cont
. Only TN429, TN438 (any
release), TN 447, TN464C (or later), TN465 (any release), TN767, TN2138,
TN2140, TN2147, TN2184, and TN2199 ports receive this timer. For DID trunks,
only TN2199 and TN429D (or later) receive this timer.
TN2140, TN2147, TN2184, and TN2199 ports receive this timer. For DID trunks,
only TN2199 and TN429D (or later) receive this timer.
Valid entries
Usage
200
to
51000
in
increments of
200
200
Enter the minimum time the switch requires to determine if a
trunk disconnects. The field cannot be blank. If the ringing
signal disappears for a duration longer than the time specified
in this field, the switch assumes the call has been disconnected.
trunk disconnects. The field cannot be blank. If the ringing
signal disappears for a duration longer than the time specified
in this field, the switch assumes the call has been disconnected.
Valid entries
Usage
20
to
5100
in
increments of
20
20
Specifies the duration (the wait-for-wink-to-end time) for a
wink-start CAMA trunk. The wink must begin before the
Outgoing Seizure Response timer expires.
wink-start CAMA trunk. The wink must begin before the
Outgoing Seizure Response timer expires.
Valid entries
Usage
5
to
255
in
increments of 1
Enter the maximum time allowed between incoming rotary
digits.
digits.
Valid entries
Usage
20
to
2550
in
increments of
10
10
Enter the duration of the shortest incoming seizure signal your
switch can recognize. For ICLID, set this field to 120. The field
cannot be blank.
switch can recognize. For ICLID, set this field to 120. The field
cannot be blank.