Lucent Technologies 8.2 User Manual
DEFINITY ECS Release 8.2
Administrator’s Guide
Administrator’s Guide
555-233-506
Issue 1
April 2000
Routing outgoing calls
187
Modifying call routing
8
Adding a new area code or prefix
A common task for system administrators is to configure their system to recognize
new area codes or prefixes.
new area codes or prefixes.
When you want to add a new area code or prefix, you look up the settings for the
old area code or prefix and enter the same information for the new one.
old area code or prefix and enter the same information for the new one.
Tip:
Use
display toll xxx
(where xxx is the prefix you want to add) to see if the
new area code or prefix number is set up as a toll call (y) or not. Some users
may not be allowed to dial toll call numbers.
may not be allowed to dial toll call numbers.
Instructions
Let’s add a new area code. When the California area code, 415, splits and portions
change to 650, you’ll need to add this new area code to your system.
change to 650, you’ll need to add this new area code to your system.
Tip:
If you do not need to use 1 for area code calls, omit the
1
in steps 1, 3, and 5
in our example. Also, enter
10
in the Total Min and Total Max fields (instead
of 11) in step 6.
To add this non-local area code:
1. Type
list ars route-chosen 14152223333
and press
RETURN
.
You can use any 7-digit number after 1 and the old area code (415). We
used 222-3333.
used 222-3333.
The ARS Route Chosen Report screen appears.
2. Write down the Total Min, Total Max, Route Pattern, and Call Type values
from this screen.
In this example, the Total Min is
11
, Total Max is
11
, Route Pattern is
30
,
and the Call Type is fnpa.
3. Type
change ars analysis 1650
and press
RETURN
.
The
AAR and ARS Digit Analysis Table
screen appears.
ARS ROUTE CHOSEN REPORT
Location: 1
Partitioned Group Number:
1
Dialed
Total
Route
Call
Node
Location
String
Min Max
Pattern Type
Number
141
11
11
30
fnpa
all