Lucent Technologies 8.2 User Manual
DEFINITY ECS Release 8.2
Administrator’s Guide
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
512
CDR System Parameters
17
EIA Device Bit Rate
Applies to G3si only. Displays if either Primary or Secondary Output Format is
eia
.
Use Enhanced Formats
Enhanced formats provide additional information about time in queue and ISDN
call charges, where available. This affects the "expanded", “teleseer”, "lsu",
"printer", and "unformatted" output formats.
call charges, where available. This affects the "expanded", “teleseer”, "lsu",
"printer", and "unformatted" output formats.
Modify Circuit ID Display
This affects the “printer,” “teleseer,” and “59-character” output formats.
Remove # From Called Number
Valid entries
300
1200
2400
9600
Enter the baud rate of the CDR device connected to the EIA
port.
port.
Valid entries
Usage
y/n
Enter
y
to enable the use of the Enhanced version of the
specified primary output format. You cannot use Enhanced
formats and ISDN formats at the same time.
formats and ISDN formats at the same time.
Valid entries
Usage
y
Enter
y
to display the circuit ID in its actual format (100’s,
10’s, units). For example, circuit ID 123 displays as 123. You
might need to verify that your output device can accept this
format.
might need to verify that your output device can accept this
format.
n
Enter
n
to display the circuit ID in its default format (10’s,
units, 100’s). For example, circuit ID 123 appears as 231.
Valid entries
Usage
y
Enter
y
to have the “#” (or “E”) symbol removed from the
Dialed Number field of the call detail record. You might need
to verify that your output device can accept this format.
to verify that your output device can accept this format.
n
Enter
n
to have the trailing “#” (or “E”) symbol appear in the
Dialed Number field whenever inter-digit time out occurs or
users dial # to indicate the end of dialing.
users dial # to indicate the end of dialing.