Manualsbrain.com
  1. Manuals
  2. Brands
  3. Lucent Technologies
  4. 8.2
  5. User Manual

Lucent Technologies 8.2 User Manual

Download
Page of 1707
DEFINITY ECS Release 8.2
Administrator’s Guide  
555-233-506  
Issue 1
April 2000
Screen reference 
578
Data modules 
17
When this option is enabled, the DLC reports the highest optioned speed and all 
the lower speeds (or the previously selected autoadjust speed) during the 
handshake process.
!
CAUTION:
Caution must be used when using this option to send information from a 
DTE/DCE that is transmitting data at higher rates than that of the far end. 
Sustained usage of this type transmission results in loss of data. Whenever 
this option is enabled, the DTE must match the highest speed selected for the 
associated DLC port.
This option is intended to be used by a DTE device operating locally at a higher 
baud rate than that of its far-end connection but transmitting relatively low 
amounts of data (for example, a user typing at a terminal). Also, this option may 
be selected whether Keyboard Dialing is selected.
NOTE:
The Low speed setting is not reported as an available speed when the Permit 
Mismatch field is 
y
.
Dial Echoing
Appears when the KYBD Dialing field is 
y
.
Disconnect Sequence
Appears when the KYBD Dialing field is 
y
. Selects the sequence for a disconnect.
Valid entries Usage
y/n
Enter 
y
 to instruct the DLC to operate at the highest selected 
speed, which is a higher rate than the far-end data module.
Valid entries
Usage
y/n
Enter 
y
 to echo characters back to the DTE. Dial echoing should 
be disabled when keyboard dialing is done by an intelligent 
device.
Valid entries
Usage
long-break
A long-break is greater than 2 seconds.
two-breaks
Two-breaks is within 1 second.